User manual

- GC7320/GC7220: Fill the water tank when the water runs low.
- GC7330/GC7240/GC7230: Fill the water tank when the ‘water tank empty’ light ashes.
- You can rell the water tank at any time during ironing.
1 Openthellingfunnellid(Fig.2).
2 Fillthewatertankwithtapwateruptothemaximumlevel(Fig.3).
Note: If the tap water in your area is very hard, we advise you to mix it with an equal amount of distilled
water, or to use distilled water only.
3 Properlyclosethellingfunnellid(‘click’).
Do not tilt or shake the steam tank when the water tank is full. Otherwise water may spill out of
thellingfunnel.
4 Ifyouhavelockedthesteamactivator,releasethesteamlock(Fig.4).
5 Brieypressthesteamactivatortoresettheiron(Fig.5).
, After approx. 10 seconds, the iron is ready for steam ironing again.
Setting the temperature
1 To set the required ironing temperature, turn the temperature dial to the appropriate
position(Fig.6).
Check the laundry care label for the required ironing temperature:
Symbol on
laundry care
label
Type of fabric Temperature
setting
Steam setting
(GC7330/7240/
GC7230only)
B Synthetic fabrics (e.g. acetate,
acrylic, viscose, polyamide,
polyester) and silk
1 MIN (see ‘Ironing
without steam’)
C Wool 2 Low
D Cotton, linen 3 to MAX Low & high
Z Please note that Z on the label
means that the article cannot be
ironed.
If you do not know what kind or kinds of fabric an article is made of, determine the right ironing
temperature by ironing a part that is not visible when you wear or use the article.
If the fabric consists of various kinds of bres, always select the temperature required by the most
delicate bre, i.e. the lowest temperature. For example: if an article consists of 60% polyester and
40% cotton, it must be ironed at the temperature indicated for polyester ( 1) and without steam.
2 Putthemainspluginanearthedwallsocketandsettheon/offswitchtoon(GC7320/
GC7220)orpresstheon/offbutton(GC7330/GC7240/GC7230)(Fig.7).
, The power-on light on the steam tank and the temperature light on the iron go on.
, The steam tank and the iron soleplate start to heat up.
, The iron is hot enough when the temperature light goes out.
Note: During ironing, the temperature light goes on from time to time. This indicates that the iron is
heating up to the right temperature.
Note: When you switch on the appliance, the steam tank produces a pumping sound. This sound is
normal and indicates that water is being pumped into the steam tank.
ENGLISH8