User manual

20
Problem Possible cause Solution
EN
The steam generator produces a
pumping sound.
Water is pumped into the boiler
inside the steam generator. This
is normal.
If the pumping sound continues nonstop, switch
off the steam generator and remove the plug
from the wall socket. Contact an authorised
Philips service centre.
The steam generator does not
produce any steam.
There is not enough water in the
water tank (the ‘water tank empty’
light ashes).
Fill the water tank.
The steam generator is not hot
enough to produce steam.
Wait until the ‘steam ready’ light lights up
continuously.
You do not press the steam trigger. Press the steam trigger and keep it pressed while
you iron.
The appliance is not switched on. Insert the plug in the wall socket and press the
on/off button to switch on the appliance.
The appliance is set to the ‘no
steam’ setting.
Set the appliance to the steam setting.
The steam generator has
switched off/the light in the on/
off button ashes.
The auto-off function/eco mode
is activated automatically when
the steam generator has not been
used for more than 10 minutes.
Press the power on/off button to switch on the
steam generator again.
Water droplets come out of the
soleplate.
When you start steam ironing and
when you continue steam ironing
after an interruption, the steam
that was still present in the hose
has cooled down and condensed
into water. This causes water drop-
lets to come out ofthe soleplate.
This is normal. Hold the iron over an old cloth
and press the steam trigger. The cloth absorbs
the drops. After a few seconds, steam instead of
water comes out of the soleplate.
Wet spots appear on the gar-
ment during ironing.
The wet spots that appear on
your garment after you have
steam ironed for some time may
be caused by steam that has con-
densed onto the ironing board.
To prevent wet spots due to condensation,
steam iron the fabric rst and then dry iron it
for a short time to dry the fabric and the ironing
board cover underneath. Replace the ironing
board cover if its foam layer has worn out. You
can also add an extra layer of felt under the iron-
ing board cover to prevent condensation on the
ironing board. You can buy felt in a fabric shop.
Water spots appear on the
garment during use of the steam
boost function.
The water spots on your garment
are caused by condensation in
the supply hose. When the supply
hose cools down, the steam that
is still present in the hose cools
down and condenses into water.
The water droplets stop coming out of the
soleplate when you have used the steam boost
function for some time.
The iron temperature is set too low.
Set the temperature dial to 2 or higher.
Flakes and impurities come out
of the soleplate or the soleplate
is dirty.
Impurities or chemicals present
in the water have deposited in
the steam vents and/or on the
soleplate.
Clean the soleplate with a damp cloth.
Too much scale and minerals have
accumulated inside the steam
generator.
Descale the steam generator regularly, see CALC
CLEAN in this manual.
Water leaks from the steam
generator.
If you tilt the steam generator
during transport or place it on an
uneven surface when the water
tank is full, water may spill out of
the water tank.
Do not tilt the steam generator when the water
tank is full.
Steam escapes from under the
Calc-Clean rinsing knob
You have not tightened the Calc-
Clean rinsing knob properly after
descaling.
Switch off the appliance and tighten the Calc-
Clean rinsing knob properly.
4239_000_7980_1_DFU Picture Rich_A5_v3.indd 20 11/17/11 11:22 AM