User Guide

15
Problem Possible cause Solution
Water ushes out of the
soleplate.
You have accidentally started the
Calc-Clean process (see chapter
'Cleaning and maintenance').
Switch o the appliance. Then switch it back on
again. Let the iron heat up until the ‘iron ready’ light
lights up steadily.
The Calc-Clean process does
not start.
You have not pressed the CALC-
CLEAN button for 2 seconds until
the appliance started beeping.
See chapter ‘Cleaning and maintenance’.
The iron leaves a shine or an
imprint on the garment.
The surface to be ironed was
uneven, for instance because you
were ironing over a seam or a fold
in the garment.
PerfectCare is safe on all garments. The shine or
imprint is not permanent and will come o if you
wash the garment. Avoid ironing over seams or
folds or you can place a cotton cloth over the area
to be ironed to avoid imprints.
There was not enough felt in the
ironing board cover.
Put an extra layer of felt material under the ironing
board cover.
The ironing board cover
becomes wet, or there are
water droplets on the oor/
garment.
Steam has condensed on the
ironing board cover after a long
ironing session.
Replace the ironing board cover if the foam or felt
material has worn out. You can also add an extra
layer of felt material under the ironing board cover
to prevent condensation on the ironing board.
You have an ironing board that
is not designed to cope with the
high steam rate of the appliance.
Put an extra layer of felt material under the ironing
board cover to prevent condensation on the ironing
board.
English