Operation Manual

Placing the tap unit onto the keg
Always clean the tap unit with hot water and, if necessary, with some
washing-up liquid before you place it on the keg and insert the tube.
1 Remove the protection cap and the tube from the keg.
2 Put the tap unit onto the connection top of the keg by pushing it
down rmly (‘click’).
If you snap the tap unit onto the keg correctly, it ts nicely between the
two chimes of the keg.
Tip: If you can move the arm of the connection top freely up and down, the tap
unit is placed properly on the keg.
Placing the tube into the tap unit
1 Insert the exible tube into the tap body.
2 Slide the projections of the tube connector under the hinge points.
3 Push the tube connector into the opening in the tap unit (‘click’).
ENGLISH10