User manual

Problem Solution
2. You may have forgotten to ll the milk reservoir before brewing a coffee
variety with milk. Fill the milk container up to the required level for the coffee
variety.
3. You pressed the Clean/Calc-Clean button to ush the milk container unit.
Full steam power is required for a thorough ushing of the milk container
unit. That is why, during the ushing process, more steam can escape than
during normal use.
4. You may have lled the milk reservoir with warm water for ushing. Fill the
milk reservoir with cold water.
5. The milk tube is not connected to the milk reservoir lid. Connect the milk
tube to the milk reservoir lid.
The lid cannot be
opened.
A vacuum may have formed under the lid. Pull the lever up as far as it will
go and wait 24 hours before opening the lid.You may need to use quite
some force to open the lid. When the lid opens, check if the sieve/hole in the
centre of the pod holder is clogged. Unclog the sieve/hole by holding the pod
holder under a running tap. If necessary, you can use a washing-up brush to
unclog the sieve or a pin to unclog the hole. To avoid this problem, never put
ground coffee (lter-ne grind) in the pod holder. Prevent pods from tearing
by placing them in the pod holder with the convex side pointing downwards.
Check if the coffee in the pod is evenly distributed when you place the pod
in the pod holder and press the pods lightly into the pod holder. If you cannot
open the lid or if the problem continues to occur, take the machine to your
dealer or to a Philips service centre.
Make sure you do not move the SENSEO
®
machine. Moving the machine,
placing it outdoors or in a cool or cold environment does not accelerate the
unlocking of the lid.
Do NOT put the SENSEO
®
machine in the fridge or freezer, as this does not
accelerate the unlocking of the lid.
The water reservoir
doesn’t seem to t.
There is always a small gap visible between the water reservoir and the
machine. This is normal. Put the water reservoir correctly on the machine.
I recently bought a
SENSEO
®
machine
but the buttons do not
work so I cannot brew
coffee.
You have to ush the machine before you use the machine to brew coffee.
Follow the steps below to ush the machine (see also chapter ‘Before rst
use’ in the user manual). • Fill the water reservoir up to the MAX indication.
• Make sure the milk container is placed. • Open the lid. • Place the 1-cup
pod holder or 2-cup pod holder without pod(s) in the machine • Close the
lid and lock the lever. • Put the plug in an earthed wall socket • Put a bowl
(with a capacity of at least 1500ml) under the coffee spout to collect the
water • Press the on/off button and subsequently press the 1-cup button and
the 2-cup button briey at the same time • The boiler lls itself with water
from the water reservoir. This takes some time (approx. 90 to 150 seconds).
The machine switches off automatically when the ushing cycle ends. During
the ushing cycle, the machine produces more noise than during a regular
brewing cycle.
ENGLISH 29