HD7850
FGH 2 3 1 E D C I J B K A L 28 27 4 26 5 25 24 6 7 18 19 20 21 22 23 1 8 17 16 9 10 11 15 12 14 13
HD7850 English 6
English Introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Make your coffee moments truly special with SENSEO®. This unique system combines the easy-to-use Philips SENSEO® coffee machine with the specially developed Douwe Egberts SENSEO® coffee pods, giving you a full, smooth coffee with a delicious foam layer.
English 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 7 Control panel (your control panel may differ from the one shown in the figure) A Coffee select button B SENSEO® black coffee indicator C Cappuccino indicator D Latte macchiato indicator E Caffè latte indicator F CLEAN/CALC CLEAN button G CALC CLEAN indicator H CLEAN indicator I Large black coffee volume indicator J Medium black coffee volume indicator K Small black coffee volume indicator L Volume select button Lid lever Seali
English instruction concerning use of the machine by a person responsible for their safety. -- Children should be supervised to ensure that they do not play with the machine. -- Do not use the machine if the plug, the mains cord or the machine itself is damaged. -- If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard.
English Before first use YOU CANNOT BREW COFFEE IF YOU HAVE NOT FLUSHED THE SENSEO® COFFEE MACHINE FIRST! Note that the buttons do not work and the light ring around the on/off button does not start to flash until you have flushed the machine. During the flushing cycle, the water in the water reservoir is flushed through the machine and the boiler is filled with water. After the flushing cycle, the coffee machine is ready for use. Flush the machine in the following way: 1 Remove the water reservoir.
English 6 Put the 1-cup pod holder q or the 2-cup pod holder qq in the machine without pod or pods. 7 Close the lid and lock the lid lever. Note: Make sure the lid lever is properly locked by pushing it down until it snaps home with a click. It is not possible to flush the machine when the lid is not properly closed. 8 Put the plug in an earthed wall socket. 9 Put a bowl (with a capacity of at least 1.5 litres) under the coffee spout to collect the water. 10 Press the on/off button 3.
English 11 12 Clean the coffee spout, the coffee collector, the pod holders, the milk container and the milk container lid with hot water and some washing-up liquid or in the dishwasher. Clean the water reservoir thoroughly in hot water, if necessary with some washing-up liquid. Now your Philips SENSEO® coffee machine is ready for use. Using the machine Preparing for use 1 Fill the water reservoir with cold water up to the MAX indication and put it back onto the machine.
English -- Use 2 coffee pods in combination with the deeper 2-cup pod holder and the 2-cup button qq if you want to make two cups of SENSEO® black coffee. 6 Place the SENSEO® coffee pod or pods properly in the centre of the pod holder, with the convex side pointing downwards. Note: Use SENSEO® coffee pods from Douwe Egberts, which have been specially designed for your SENSEO® coffee machine and give a full and round taste.
English 13 1 Move the milk container lever upwards to release the milk container unit. Pull the milk container unit forwards to remove it from the machine. 2 Press the milk container lid release lever (1) and remove the milk container lid from the milk container (2). 2 1 3 Fill the milk container with cold milk straight from the refrigerator (5-8°C) up to the level required for the coffee variety. -- ¶= amount of milk required to brew one cup of cappuccino.
English Brewing black coffee, cappuccino, latte macchiato or caffè latte Coffee varieties with milk Each coffee variety with milk has its own distinctive brewing process: -- Cappuccino ¶ is a rich combination of one-third coffee and two-thirds of freshly frothed hot milk with a creamy froth layer. When you brew a cappuccino, your cup is first filled with hot milk froth and then strong black coffee is brewed onto the froth. This causes the coffee to sink below the froth layer.
English 15 Tip: Do not use cups that are too large as they cause the coffee to get cold more quickly. The amounts of the coffee varieties with milk are: -- 160ml for cappuccino ¶. -- 220ml for latte macchiato õ. -- 190ml for caffè latte %. Note:The amount of the milk varieties may vary due to variations in milk temperature, type of milk, how clean the milk container unit is, etc. 5 Press the button indicating the number of cups of SENSEO® coffee you want to brew. -- Press the 1-cup button q for one cup.
English 16 1 2 Flushing after every use (when you do not plan to froth milk again straightaway). After each use, the CLEAN indicator lights up to remind you to flush the milk container unit. To flush the milk container unit, fill the milk reservoir with water and press the CLEAN button. See section ‘Flushing after every use with the CLEAN button’ in this chapter. Cleaning all parts of the milk container unit after the last use of the day.
English 1 2 2 5 To fasten the milk container lid onto the milk container, first push the front of the milk container lid onto the edge of the milk container (‘click’) (1) and then push the rear end onto the milk container (‘click’) (2). 6 Slide the milk container unit into the coffee machine (1) and push down the milk container lever (‘click’) (2). 1 7 Place an empty cup under the coffee spout. 8 Press the CLEAN button. ,, The milk container unit is flushed.
English 18 -- Pull at the tab on top of the milk container lid cover to open the cover. -- Pull out the steam inlet (this part stays attached to the lid by means of a plastic strip) Note:You can only pull the steam inlet out of the milk container lid when the milk container lid cover is open. 3 Pull the milk tube off the milk container lid. 4 Clean the milk container, the milk container lid and the milk tube in the dishwasher or with a washing-up brush in hot water with some washing-up liquid.
English 1 2 19 6 To fasten the milk container lid onto the milk container, first push the front of the milk container lid onto the edge of the milk container (‘click’) (1) and then push the rear end onto the milk container (‘click’) (2). Note: Make sure all parts of the milk container lid are dry before you reassemble the lid. Note: Always check if the lid is fixed properly onto the milk container to prevent spillage when you place the milk container unit in the machine.
English 5 Clean the coffee spout cover, the coffee spout, the coffee collector and the drip tray in hot water, if necessary with some washing-up liquid, or in the dishwasher. 6 Hold the cup tray in your hand while you clean it with hot water. If necessary, use some washing-up liquid. The cup tray can also be cleaned in the dishwasher. To clean the cup tray, always remove it from the machine, as it might prove sharp when handled incorrectly. Always handle it carefully.
English 21 11 Clean the water distribution disc with a moist cloth. Be careful when you do this; make sure that the rubber sealing ring does not get stuck under the edge of the water distribution disc. If it does, the coffee machine starts leaking. Note: Be careful not to damage the metal tab on the water distribution disc. Flushing the coffee machine If you have not used the coffee machine for three days, you have to flush it with fresh water before you use it again.
English 22 1 2 5 Press the on/off button 3 (1) and subsequently press the 1-cup button q and the 2-cup button qq briefly at the same time (2). ,, During the flushing cycle, the water in the water reservoir is flushed through the machine. While this happens, water comes out of the spout. The flushing cycle takes some time (approx. 90 to 150 seconds). The machine switches off automatically when the flushing cycle ends.
English 23 Descaling procedure The descaling procedure consists of three cycles: -- Descaling cycle (approx. 35 minutes) -- Rinsing cycle with used pod (approx. 3 minutes) -- Rinsing cycle without used pod (approx 3 minutes) Descaling cycle 1 Mix 50 grams of citric acid with 1 litre of water in a measuring jug. Stir until the powder has completely dissolved. 2 Remove the water reservoir. 3 Take the Calc-Clean tool out of the recess in the back of the machine.
English 8 Press the on/off button 3. ,, The machine is ready for use when the light ring around the on/off button lights up continuously. 9 Place the 1-cup pod holder q with a used coffee pod in the coffee machine. Close the lid and make sure it is properly locked. Note: Always put a used coffee pod in the pod holder when you descale the machine.This pod serves as a ‘filter’ to prevent the sieve in the pod holder from getting clogged with scale residues. 10 Put a bowl with a capacity of at least 1.
English 25 4 Rinse the machine a second time by repeating steps 1 and 2 above. 5 Remove the Calc-Clean tool from the coffee spout. Reinsert the Calc-Clean tool into the recess in the back of the machine. The descaling procedure is now finished and the machine is ready to brew coffee again. Frost-free storage If the coffee machine has already been used and therefore has been flushed with water, it may only be used and stored in a frost-free place to prevent it from becoming damaged.
English Troubleshooting This chapter summarises the most common problems you could encounter with the machine. If you cannot find the solution to your problem, you can find more solutions at www.philips.com/support. If you still cannot solve the problem, contact the Consumer Care Centre in your country (see chapter ‘Guarantee and service). Problem Solution The SENSEO machine does not produce good or enough frothed milk. ® 1.The milk container unit may be dirty.
English Problem 27 Solution 2. Perhaps you filled the milk container beyond the level required for the coffee variety you wanted to brew. 3. You may have used milk that is not cold enough. If the milk temperature is above the 8°C, the machine uses less milk. Make sure you use cold milk straight from the refrigerator (5-8°C). The coffee varieties with milk are not hot enough. 1.
English Problem Solution The light ring around the on/off button continues to flash rapidly. 1. When the light ring around the on/off button flashes, there is not enough water in the water reservoir to brew coffee. To brew coffee, the water in the water reservoir must be above the MIN level. 2. You may have selected a coffee variety with milk (cappuccino, caffè latte or latte macchiato) and you did not place the milk container in the machine or did not place it correctly.
4222.200.0445.