User manual

2 Turn the hot water/steam wand with the automatic milk frother towards

the machine until the automatic milk frother touches the machine and is

in horizontal position.

3 Remove the lid of the milk carafe and pour the milk in the milk carafe.

Close the lid of the milk carafe.

4 Insert the other end of the suction tube into the milk carafe till the bottom

of the milk carafe.

5 Place a large cup under the automatic milk frother and the coffee spout.

6 Select the coffee strength by turning the dial to one or two beans. Select

2 beans for a stronger taste.

7 Press the cappuccino button. The machine dispenses first the milk and

then coffee.

It will take a few seconds before the machine stops dispensing.

Note: If you want to interrupt the brewing cycle press the cappuccino

button again.

8 The amount of coffee and milk can be customized, see chapter 'Adjusting

the machine', section 'Adjusting coffee and milk length'.

9 Place a cup under the automatic milk frother. Perform a quick clean

dispensing hot water for 3-5 seconds after brewing a cappuccino, see

chapter 'Cleaning and maintenance', section 'Quick Clean of the milk

system'.

10 Remove the milk tube connector from the automatic milk frother.

11 Plug the milk connector to the pin on the milk container lid and put the

milk container in the fridge.

Note: After dispensing a milk based beverage perform a quick clean of

the milk system by dispensing hot water for 5 seconds.

Frothing milk

Warning: Danger of burning! Dispensing may be preceded by

small jets of hot water. When steam is used, the hot water/steam

wand and automatic milk frother could be hot. Only grab the

steam wand by its protective handle.

1 Follow steps 1 to 5 from 'Brewing cappuccino' and turn the dial to the

steam/milk clean icon to froth milk.

English