Always here to help you Register your product and get support at www.saeco.com/welcome HD8758/57 HD8758-57_4219_460_3151_1_COVER_BOOKLET_A5_bl.
English 5
1 5 2 6 3 7 8 9 10 4 11 12 13 14 ESPRESSO STEAM ESPRESSO LUNGO HOT WATER 19 18 15 17 AR OM A STR EN 20 MENU GTH 16 21 28 22 27 23 26 25 24
English 5 Contents Introduction Important safeguards 5 6 Caution Instructions for the power supply cord 6 7 General description Important 7 7 Warning Caution Electromagnetic fields (EMF) 8 8 9 The display First installation 9 10 Manual rinsing cycle 10 Water filter 10 Installing the water filter Replacing the water filter Measuring the water hardness 11 11 11 Using the machine 12 Brewing coffee with beans Brewing coffee with pre-ground coffee Adjusting the coffee quantity Adjusting the g
English your product at www.saeco.com/welcome. This quick start guide applies to all Intelia/Intelia Deluxe models with classic milk frother. The machine is suitable for preparing espresso coffee using whole coffee beans. Important safeguards When using electrical appliances, basic safety precautions should always be followed, including the following: 1 Read all instructions. 2 Do not touch hot surfaces. Use handles or knobs.
English 7 Instructions for the power supply cord - A short power-supply cord (or detachable power-supply cord) is to be provided to reduce risks resulting from becoming entangled in or tripping over a longer cord. - Longer detachable power-supply cords or extension cords are available and may used if care is exercised in their use. - If a long detachable power-supply cord or extension cord is used.
English Warning - Check if the voltage indicated on the machine corresponds to the local voltage before you connect the machine - Connect the machine to a grounded wall outlet. - Do not let the power supply cord hang over the edge of a table or counter, or touch hot surfaces. - Never immerse the machine, power plug or power supply cord in water (danger of electrical shock). - Do not pour liquids on the power supply cord connector. - Never direct the hot water jet towards body parts: danger of burns.
English 9 - The machine is for household use only. It is not intended for use in environments such as canteens, staff kitchen of shops, offices, farms or other work environments. - Always put the machine on a flat and stable surface. - Do not place the machine on hot surfaces, directly next to a hot oven, heater or similar source of heat. - Only put roasted coffee beans into the coffee bean hopper.
English - MENU button = DOWN button: press this button to scroll down through the display menu. MENU First installation 1 2 3 4 5 6 7 8 9 10 11 12 Slide the drip tray with drip tray cover into the machine. Remove the water tank. Fill the water tank to the MAX level with fresh water. Fill the coffee bean hopper with coffee beans. Insert the small plug into the socket located on the back of the machine. Insert the mains plug into the wall socket.
English 11 Installing the water filter 1 Remove the small white filter from the water tank and store it in a dry place. Note: Please keep the small white filter for future use.You will need it for the descaling process. FILTER FILTER 2 Remove the filter from its packaging and immerse it in cold water with the opening pointing upwards. Press the sides of the filter gently to let out the air bubbles. 3 Place the filter in the empty water tank. Press it down until it cannot move any further.
English 1 Immerse the water hardness test strip (supplied with the machine) in fresh water for 1 second. 2 Remove the water hardness strip and and wait for 1 minute. 3 Check how many squares have changed into the red color and check the water hardness in below table.
English 13 coffee compartment. If you add more pre-ground coffee, the excess coffee will end up in the coffee grounds drawer. 1 Open the lid of the pre-ground coffee compartment. 2 Pour one measuring scoop of pre-ground coffee into the compartment. Caution: Do not put any other substance than pre-ground coffee in the pre-ground coffee compartment, as this may damage the machine. 3 Place the lid back on the pre-ground coffee compartment. 4 Place a cup under the coffee dispensing spout.
English 1 Place a jug under the classic milk frother. 2 Press the HOT WATER button. Hot water dispensing starts automatically. 3 Press the OK button to stop hot water dispensing. Remove the container. Descaling You have to descale the machine when the display shows the CALC CLEAN icon. If you do not descale when the display shows the CALC CLEAN icon, the machine may stop working properly. In this case, repairs are not covered by the warranty.
English CALC CLEAN 15 14 Press the OK button to start the rinsing cycle (this takes approximately 4 minutes). - The display shows the following icon to indicate that the rinsing cycle is finished. 15 The display shows a tick icon. 16 Rinse the water tank and fill it with fresh water up to the MAX level. Place the water tank back into the machine. 17 Press the OK button to return to the main menu. 18 The display shows the following icon to indicate that the machine is heating up.
English 3 To remove the brew group, press the lever and pull the brew group out of the machine. 4 Rinse the brew group with fresh water and let it air dry. 1 2 5 To place the brew group back, make sure that the lever is in contact with the base of the brewing unit. Note: If it is not in contact with the base, push it down. 6 Make sure the locking hook of the brew group is in the correct position. To position the hook correctly, push it upwards until it is in uppermost position.
English 1 17 Apply some lubricant around the shaft in the bottom of the brewing unit. 2 Apply lubricant to the rails on both sides, as shown in the illustration. 3 Slide the brew group back into the machine along the guiding rails on the sides until it clicks into position. Then place the coffee residues drawer back in the machine. Classic milk frother cleaning (daily) Remove the external part of the classic milk frother and rinse it with fresh water.
English To buy spare parts, visit www.shop.philips.com/service or go to your Saeco dealer or authorized service center. You can also contact the Philips/Saeco hotline in your country. Ordering maintenance products - MAVEA (CA6702) - Descaling solution (CA6700) Disposal This product may contain lead and mercury. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or visit www.recycle.philips.com.
English 19 - Close the service door. - Remove the coffee grounds container and empty it. - There is too much powder in the brew group. Clean the brew group. - If an error code is triggered, check the section 'Meaning of error codes' to see what the code on the display means and what you can do. The machine cannot be used when this icon is on the display. - You forgot to place the lid on the pre-ground coffee compartment.
English 5 Water circuit problem There is air in the water circuit. Other error codes Remove and place back the water tank a couple of times. Make sure you insert it into the machine properly. Check if the water tank compartment is clean. Switch the machine off and switch it back on again after 30 seconds. Try this 2 or 3 times. If the above solutions do not help to remove the error code icon from the display and bring the machine back to normal working order, contact the Philips Saeco hotline.
English The brew group cannot be inserted. The machine is still in the descaling process. You cannot remove the brew group when the descaling process is active. First complete the descaling process and then remove the brew group. The brew group is not in the correct position. The brew group was not put in rest position before it was placed back. Make sure that the lever is in contact with the base of the brew group and that the hook of the brew group is in the correct position.
English The coffee comes out slowly. The grind is ground too finely. Change the grinder to a coarser setting. The brew group is dirty. Clean the brew group. The coffee exit duct is blocked. Clean the coffee exit duct with the handle of the multifunctional tool or a spoon handle. The machine circuit is blocked by Descale the machine. limescale. The milk does not froth. The automatic milk frother is dirty or not assembled or installed correctly.
www.saeco.com/welcome HD8758-57_4219_460_3151_1_COVER_BOOKLET_A5_bl.indd 2 4219.460.3151.
