User Manual

4 Open the lid of the bean hopper. Fill the bean hopper with coffee beans

and close the lid.

Note:Do not overfill the bean hopper to avoid damage to the grinder.

Caution: Only use espresso beans. Never use ground coffee, unroasted

coffee beans or caramelized coffee beans, as this may cause damage to

the machine.

Note: Do not add pre-ground coffee, water or coffee beans in the coffee

exit duct.

5 Insert mains plug into a wall socket (1) and insert the small plug into the

socket located on the back of the machine (2).

6 Set the main switch to the ON position to switch on the machine.

7 Insert the hot water dispensing spout.

8 Press the ON/OFF button to switch on the machine.

Circuit priming

During the initial heat-up process, fresh water flows through the internal

circuit to heat up the machine. This takes a few seconds.

1 Place a container under the hot water dispensing spout.

English