operation manual

ENGLISH

Machine actions Causes Solutions

The machine grinds the

co ee beans but no co ee

is brewed (see note).

There is no water. Fill the water tank and prime the circuit

(see the "Manual Rinse Cycle" chapter).

The brew group is dirty. Clean the brew group (see the "Weekly

Cleaning of the Brew Group" chapter).

This might occur when the ma-

chine is automatically adjusting

the dose.

Brew some cups of co ee as described

in the “Saeco Adapting System” chapter.

The dispensing spout is dirty. Clean the dispensing spout.

The co ee is too weak (see

note).

This might occur when the ma-

chine is automatically adjusting

the dose.

Brew some cups of co ee as described

in the “Saeco Adapting System” chapter.

The ground co ee is too coarse. Change co ee blend or adjust grind-

ing as explained in the “Adjusting the

Ceramic Co ee Grinder” chapter.

Co ee is brewed slowly

(see note).

The co ee grind is too  ne. Change co ee blend or adjust grind-

ing as explained in the “Adjusting the

Ceramic Co ee Grinder” chapter.

The circuits are clogged. Perform a descaling cycle.

The brew group is dirty. Clean the brew group (see the “Weekly

Cleaning of the Brew Group” chapter).

Co ee leaks out of the

dispensing spout.

The dispensing spout is clogged. Clean the dispensing spout and its

holes.

Note:

These problems can be considered normal if the co ee blend has been

changed or if the machine has just been installed. In this case, wait until

the machine performs a self-adjusting operation as described in the “Saeco

Adapting System” chapter.