User manual
Table Of Contents
When you set the alarm, you choose an alarm time and (only in case of HF3470) the type of sound
you want to wake up to. The alarm is set when the alarm symbol is visible on the display. The light
intensity slowly increases to the selected level during the last 30 minutes before the set alarm time.
The sound slowly increases in 90 seconds to the selected level after the set alarm time.
Note: You can set the light intensity by pressing the light on/off button and then pressing the light intensity
+ or - button and you can set the alarm volume by pressing the volume increase or decrease button. If
you do not want to wake up to the lamp or to a sound, set the light intensity or volume level to OFF. See
sections ‘Using the lamp’ and ‘Radio/volume’ in this chapter.
1 Push the control lever down to the middle position to switch on the alarm. (Fig. 13)
, The hour indication of the alarm time ashes (Fig. 14).
, To adjust the time, follow steps 2 to 5. If the alarm time is correct, just wait a few seconds.
2 Press the menu + or - buttons to select the hour (Fig. 9).
Note: You can only do this when the hour indication ashes. If this is not the case, push the control lever
up and down again to enter the alarm time mode. You can also set the alarm time in the menu. See
section ‘Menu functions’ in this chapter.
3 Press the SELECT button to conrm (Fig. 10).
, The minute indication of the alarm time starts to ash (Fig. 15).
4 Press the menu + and - buttons to select the minutes. (Fig. 9)
5 Press the SELECT button to conrm or wait for a few seconds (Fig. 10).
, The appliance leaves the menu and the display shows the clock time.
The alarm time is now set.
To switch off the alarm function, push up the control lever to the top position.
Note: The lamp stays on to light your room. You can switch off the lamp by pressing the light on/off
button.
Note: The alarm (sound and/or light) automatically switches off after 90 minutes.
See section ‘Menu functions’ above.
You can choose one of the following sounds:
- Radio (Fig. 16)
- Birds (Fig. 17)
- Beep (Fig. 18)
1 Push down the control lever to the bottom position when the alarm goes off. (Fig. 19)
, The lamp continues to be on at the selected intensity level, but the alarm sound stops. After
9 minutes, the wake-up sound is automatically played again.
Note: The 9-minute snooze time is xed. This time cannot be adjusted.
Note: If you push down the control lever with too much force, it may jump back to off position.
If you want to get a quick demonstration (60 seconds) of the gradually increasing light level and
sound level, activate the test function of the appliance.
1 Push the control lever down to the bottom position for a few seconds until TEST appears on
the display (Fig. 20).
9