Operation Manual

– 41 –
TROUBLE-
SHOOTING
Problems when establishing a connection
Possible cause RemedyError
TRANSM. ERROR
CHECK
DISPLAY
Error report
The telephone connection is of poor
quality.
The recipient has a paper jam or has run
out of paper.
Try again.
Call your fax correspondent.
NO CONNECTION
or
REDIAL FAILED
Your fax correspondent’s line is busy,
does not answer or a different device
answers.
Try later or draw your fax
correspondent’s attention to a possible
installation fault.
NO LOOP CURRENT
Your fax machine is not properly installed
or not properly plugged in.
Check the installation of your fax
machine.
NO DIALTONE
You are connected to a PABX system.
You have connected your telephone
cable to socket on the bottom of your fax
machine identified with EXT.
Check the settings in function 15.
Connect your telephone cable to the
socket on the bottom of your fax
machine identified with LINE.
When you lift the handset of your
fax machine you do not hear the
dial tone.
You have connected the telephone cable
to the socket on the bottom of your fax
machine identified with EXT.
Connect your telephone cable to the
socket on the bottom of your fax
machine identified with LINE.
busy
or
fax transmissions are constantly
interrupted.
Your fax correspondent has a fax
machine that cannot receive the usual
standard identifying signals.
Try to send the fax manually: press the
DIAL or LOUDSPEAKER key and dial
the fax number. You will hear the call
being established. If the receiver is using
an automatic answering machine, wait
until you hear a tone after the
prerecorded message and then press the
START key.
You cannot phone or send faxes. Wrong dialling mode selected.
You are operating your fax machine on a
private branch exchange and have not
set it accordingly.
Change the dialling mode with
function 15.
In Function 15, select PABX: Yes.
You cannot receive any faxes
(you have set the ringing signals
with EXPERT mode).
You have set the total number of rings
(TOTAL RINGS: _) to a too high value.
For many fax machines, the call
establishment procedure is too long, and
transmission is interrupted.
Set the total rings or the tollfree rings to a
lower value than five in function 31 or 32
FAX:EXPERT.