operation manual
1
Snap the retractable bristle brush onto the appliance.
See ‘Preparing for use’, section ‘Connecting and disconnecting
attachments’.
Do not insert the mains plug into the wall socket until after you have
connected the attachment.
Making small curls
We advise you to perform a curl test to determine how long the brush
should be held in your hair to achieve a good result. Start with 8 to 10
seconds. You may have to hold the brush in your hair longer for tighter
curls. Less tight curls will require less than 8 seconds.
1 Divide the hair into locks.
2 Take a lock of hair and wind it round the brush. Make sure the end
of the lock is wound in the required direction.
Do not wind too much hair round the brush at a time.
Do not wind a lock of hair more than twice round the brush.
Note: The thinner the lock of hair, the tighter the curl will be.
Note: Make sure the lock of hair is in contact with the barrel of the brush.
If you wind the hair at right angles to the scalp, you will give your
hair optimum lift and volume.
3 Switch the appliance on (Fig. 4).
HP4636 only: Switch the appliance on by selecting the preferred
setting: (Fig. 5)
I: gentle airow for easy styling
II: warm airow for fast styling
4 Keep the brush in your hair until the hair is warm to the touch.
5 Switch the appliance off and remove the brush from your hair by
pushing and turning the bristle retraction button in the direction of
the arrows (Fig. 6).
,
,
-
-
ENGLISH 9