User Manual

ENGLISH8
Preparing the blender for use
1 Assemble the sealing ring (E) on the blade unit (D) (fig. 1).
2 Screw the blade unit anticlockwise onto the bottom of the blender jar (C) until the blade
unit is fixed properly (fig. 2).
3 Mount the blender jar, with the blade unit attached onto the motor unit (A) and fix it by
turning it clockwise until you hear a 'click' .The blender jar can be mounted in two positions
(fig. 3 and fig. 4).
4 Make sure that the appliance is plugged in.
How to use the blender
1 Put the ingredients in the blender jar.
2 Place the lid on the blender jar.
3 Close the lid by pushing it down and turning the lid clockwise until you hear a 'click' (fig. 5).
4 Insert the measuring cup into the opening in the lid.
5 Turn the control knob to speed 1 or 2.
Turn the control knob to 'pulse' position if you want to process ingredients very briefly.
6 Do not let the appliance run for more than 3 minutes at a time.
Disassembling the blender
1 Unplug the appliance.
2 Remove the lid with the measuring cup from the blender jar.
3 Remove the blender jar with the blade unit attached to it from the motor unit.
4 Always clean the removable parts immediately after use.
Tips
- If you want to crush ice cubes, put not more than 6 ice cubes (of approx. 24x35x25mm) in the
blender jar and turn the control knob to pulse position a few times.
- Cut meat or other solid ingredients into smaller pieces before putting them in the blender jar.
- Do not process a large quantity of solid ingredients at the same time.To get good results, we
advise you to process these ingredients in a series of small batches.
- To make tomato juice, cut the tomatoes in four and drop the pieces through the opening in the
lid onto the rotating blades.
Filter Only types HR1724 and HR1727
With this filter you can make delicious fresh fruit juices, cocktails or soy milk .The filter prevents pips
and skins from ending up in your drink.
Never overload the filter. Do not put more than 50g of unsoaked dried soy beans or 150g of
fruit in the filter at the same time.
Preparing the filter for use
1 Mount the blender with the blade unit attached to it onto the motor unit (A) and fix it by
turning it clockwise until you hear a click (fig. 3).The blender jar can be mounted in two
positions.
2 Put the filter (K) in the blender jar (fig. 6).
Make sure that the grooves of the filter fit exactly onto the ribs inside the blender jar.