User manual

69Essence
Solution
Turn the bowl or lid or the blender jar clockwise until
you hear a click. Check if the screw cap has been
correctly assembled on the motor housing when the
blender is not used. Make sure that the dots indicated
on the bowl and lid are directly opposite each other
and the dot on the bowl is directly opposite the dot
on the motor housing. In case the blender is attached,
make sure the rib on the blender jar is directly
opposite the print on the motor housing.The red light
will stop blinking as soon as all attachments have been
correctly assembled.
The thermal safety cut-out has probably cut off the
power supply to the appliance because it has
overheated. 1) Press the stop button. 2) Unplug the
appliance. 3) Let the appliance cool down for
60 minutes. 4) Put the mains plug in the socket.
5) Switch the appliance on again.
Press the button for the process you want.
If both the blender jar and the food-processing bowl
have been mounted correctly, only the blender will
work. If you want to use the food-processing bowl,
remove the blender jar and assemble the screw cap.
When the maximum load of the motor has been
reached, pressing the + or - button will not have the
expected effect.This will especially happen when you
are processing large quantities of dough. Check the
quantities and processing times mentioned in the
table.
Check if you have really turned the bowl and the lid
clockwise as far as the point where you hear a click.
Problem
The appliance
doensn't go on and
the light ring round
the stop button starts
to blink red after a
process button or the
pulse button has been
pressed.
The appliance
suddenly stopped
running
You have pressed the
wrong process button
Both the blender jar
and the food
processing bowl are
attached, but only the
blender works.
The + or - button
does not respond
during certain
processes.
The kneading or
balloon beater doesn't
turn.
EN
|
Troubleshooting guide
Solution
No!
Check whether the cutting edges of the cutter unit
are pointing outwards.
The parts have been cleaned in the dishwasher.You
should clean all parts by hand and dry them
immediately with a tea towel.
Make sure the gear housing and the cutter housing
have been assembled correctly.You will hear a click
when they have been fastened properly.
No!
Problem
Can I also mince
bones or bacon rind
with the meat mincer?
The meat looks as if it
has been 'pressed
through' rather than
minced.
The metal parts of
the meat mincer look
rusty.
The meat mincer
does not work.
Is it possible to mince
frozen meat with the
meat mincer?
PL
|
Rozwiązywanie problemów
Rozwiązanie
Obróć w kierunku zgodnym z ruchem wskazówek
zegara misą malaksera, pokrywą lub dzbankiem
blendera, aż usłyszysz kliknięcie. Sprawdź, czy na
obudowę silnika została prawidłowo wkręcona
zatyczka podczas nieużywania blendera. Upewnij się,
czy kropka na pokrywce oraz kropka na misce znajdują
się dokładnie naprzeciwko siebie i czy kropka na misce
znajduje się dokładnie naprzeciw kropki na obudowie
silnika.W przypadku założenia blendera sprawdź, czy
występ na misce blendera znajduje się dokładnie
naprzeciw nadruku na obudowie silnika. Z chwilą
prawidłowego założenia wszystkich akcesoriów
przestanie migotać czerwona lampka.
Problem
Urządzenie nie
uruchamia się i po
wciśnięciu przycisku
przerabiania lub
przycisku pracy
impulsowej pierścień
świetlny wokół
przycisku zatrzymania
zaczyna migotać w
kolorze czerwonym.