Always there to help you Register your product and get support at www.philips.
Contents 1 Important Safety Care for your product Care of the environment 2 Your home theater Main unit Remote control Connectors 2 2 3 3 4 4 4 5 7 Product specifications 20 8 Troubleshooting 22 9 Notice Copyright Trademarks 24 24 24 10 Language code 25 3 Connect and set up 6 Connect speakers 6 Connect to TV 7 Connect audio from TV and other devices 9 Set up speakers 9 Set up EasyLink (HDMI-CEC control) 10 4 Use your home theater
1 Important Read and understand all instructions before you use your home theater. If damage is caused by failure to follow instructions, the warranty does not apply. Safety Risk of electric shock or fire! • Never expose the product and accessories to rain or water. Never place liquid containers, such as vases, near the product. If liquids are spilt on or into the product, disconnect it from the power outlet immediately. Contact Philips Consumer Care to have the product checked before use.
• • • of children at all times! If swallowed, the battery can cause serious injury or death. Severe internal burns can occur within two hours of ingestion. If you suspect that a battery has been swallowed or placed inside any part of the body, seek immediate medical attention. When you change the batteries, always keep all new and used batteries out of reach of children. Ensure that the battery compartment is completely secure after you replace the battery.
2 Your home theater Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your home theater at www.philips.com/welcome. Main unit Load Pause Mute Remote control This section includes an overview of the remote control. a q b p o a Disc compartment b Display panel c c (Open/Close) Open or close the disc compartment, or eject the disc. d d (Play/Pause) Start, pause or resume play.
a (Standby-On) Switch the home theater on or to standby. • When EasyLink is enabled, press and hold for at least three seconds to switch all connected HDMI CEC compliant devices to standby. • b Source buttons • DISC: Switch to disc source.Access or exit the disc menu when you play a disc. • AUDIO SOURCE: Select an audio input source. • RADIO: Switch to FM radio. • USB: Switch to USB storage device. c Navigation buttons • Navigate menus.
c AUDIO IN Audio input from an MP3 player (3.5mm jack). 3 Connect and set up Back connectors This section helps you connect your home theater to a TV and other devices, and then set it up. For information about the basic connections of your home theater and accessories, see the quick start guide. a AC MAINS Fixed AC power cable. b SPEAKERS Connect to the supplied speakers and subwoofer. c VIDEO OUT Connect to the composite video input on the TV.
SUB WOOFER FRONT LEFT FRONT CENTER FRONT RIGHT 5 Place the rear surround speakers to the left and right side of your seating position, either in line with it or slightly behind it. SUBWOOFER (subwoofer): Place the subwoofer at least one meter to the left or right of the TV. Leave about 10-centimeter clearance from the wall. Connect to TV REAR LEFT REAR RIGHT * The actual speaker shapes may vary from the illustration above.
• 3 HDMI-CEC is a feature that enables CEC compliant devices that are connected through HDMI to be controlled by a single remote control, such as volume control for both the TV and the home theater. (see 'Set up EasyLink (HDMI-CEC control)' on page 10) If you cannot hear the TV audio through your home theater, set up the audio manually.
4 When you watch videos, switch your TV to the correct video input. For details, see the TV user manual. Option 2: Connect audio through analog audio cables Basic quality audio Connect audio from TV and other devices AUDIO IN- AUX VCR Play audio from TV or other devices through your home theater speakers. Use the best quality connection available on your TV, home theater, and other devices.
Set up EasyLink (HDMI-CEC control) This home theater supports Philips EasyLink, which uses the HDMI-CEC (Consumer Electronics Control) protocol. EasyLinkcompliant devices that are connected through HDMI can be controlled by a single remote control. Note •• Depending on the manufacturer, HDMI-CEC is known by many names. For information on your device, see the user manual of the device. •• Philips does not guarantee 100% interoperability with all HDMI-CEC devices.
3 4 5 6 Select [Video], and then press OK. Select [HDMI Setup] > [EasyLink Setup] > [Sys Audio Control] > [On]. • To play the audio from the TV speakers, select [Off], and skip the following steps. Select [HDMI Setup] > [EasyLink Setup] > [Audio Mapping]. Follow the onscreen instructions to map the connected device to the audio inputs on your home theater.
Play buttons Button Action Navigation buttons OK (Play/ Pause) Navigate menus. / / Navigation buttons (left/right) Navigation buttons (up/down) DISC AUDIO SYNC OPTIONS Confirm an entry. Start, pause or resume play. Stop play. Skip to the previous or next track, chapter or file. Fast backwards or fast forwards. Press repeatedly to change the search speed. Rotate the picture clockwise or counter-clockwise. Flip the picture vertically or horizontally. Access or exit the disc menu.
»» The DivX VOD registration code for your home theater is displayed. Note •• Make sure that the subtitle file has the exact same name as the video file. For example, if the video file is named 'movie.avi', name the subtitle file as 'movie.srt' or 'movie.sub'. •• Your home theater supports the following file formats: .srt, .sub, .txt, .ssa, .ass, smi, and .sami. If the subtitles do not appear correctly, change the character set.
2 »» The video options menu is displayed. Depending on the video source, some options are not available. Press the Navigation buttons buttons and OK to select and change: • [Info]: Display the play information. • [PBC]: Enable or disable the content menu navigation of VCD and SVCD discs with Play Back Control feature. • [Aspect ratio]: Select a display ratio of picture that matches your TV screen. • [Repeat]: Select a repeat play mode. • [Zoom]: Zoom into a video scene or picture.
1 Play buttons Button Action / or Alphanumeric buttons Navigation buttons Select a preset radio station. RADIO Left/Right: Search for a radio station. Up/Down: Fine tune a radio frequency. Press to stop the installation of radio stations. Press and hold to erase the preset radio station. Manual: 1) In radio mode, press RADIO. 2) When a radio frequency blinks, press OK to store the radio station. 3) Repeat step 1 and 2 to store other stations.
• • • [Karaoke Idol]: Have a Karaoke contest with your friends. Follow the on-screen instructions to start the contest. [Key Shift]: Change the pitch to match your voice. [Vocal]: Select a Karaoke audio mode, or turn off original vocals. Choose sound This section helps you choose the ideal sound for your video or music. Sound mode Select predefined sound modes to suit your video or music. 1 Press SOUND repeatedly to select a sound mode.
5 Change settings The home theater settings are already configured for optimal performance. Unless you have a reason to change a setting, we recommend that you keep the default setting. Note •• You cannot change a setting that is grayed out. •• To return to the previous menu, press BACK. To exit the menu, press (Home). Language settings Onscreen display language 1 2 3 Press (Home). Select [Setup] and then press OK. Select [General] and then press OK.
Audio settings 1 2 3 Press (Home). Select [Setup] and then press OK. Select [Audio] and then press OK. • [HDMI Audio]: Set the HDMI audio output from your TV, or disable HDMI audio output from the TV. • [Audio Sync]: Set audio delay if audio and video cannot be matched. • [Speaker Setup]: Set up speakers for best surround sound experience. • [Sound Mode]: Select a predefined sound mode to suit your video and music.
Restore default settings 6 Update software 1 2 3 Philips continually tries to improve its products. To get the best features and support, update your home theater with the latest software. 4 Press (Home). Select [Setup] and then press OK. Select [Preferences] > [Default], and then press OK. Follow the onscreen message to restore default setting. »» Your home theater is reset to its default settings, except for password, parental control and disc lock settings.
Step 1: Download the latest software 1 2 3 4 5 6 Connect a USB flash drive to your computer. 7 Product specifications In your web browser, go to www.philips. com/support. At the Philips Support website, find your product and locate the Software and drivers. »» The software update is available as a zip file. Note •• Specifications and design are subject to change without notice. Save the zip file in the root directory of your USB flash drive.
• • Video: .avi, .divx, .mpg, .mpeg, Picture: .jpg, .jpeg Amplifier • • • • Total output power: 300W RMS (30% THD) Frequency response: 20 Hz-20 kHz / ±3 dB Signal-to-noise ratio: > 65 dB (CCIR) / (A-weighted) Input sensitivity: • AUX: 2 V • AUDIO IN: 1 V Video • • Signal system: PAL / NTSC/Multi HDMI output: 480i/576i, 480p/576p, 720p, 1080i, 1080p Audio • • • S/PDIF Digital audio input: • Optical: TOSLINK Sampling frequency: • MP3: 32 kHz, 44.1 kHz, 48 kHz • WMA: 44.
• • • • • • • Speaker impedance: 4 ohm Speaker drivers: 1 x 63.5 mm (2.5") full range Dimensions (WxHxD): • HTD3510: 85 x 88 x 83 mm (front/ rear) • HTD3540: 85 x 159 x 80 mm (front); 240 x 1006 x 240 mm (rear) • HTD3570: 240 x 1006 x 240 mm (front/rear) Weight (front): • HTD3510: 0.25 kg/each • HTD3540: 0.35 kg/each • HTD3570: 2.56 kg/each Weight (rear): • HTD3510: 0.25 kg/each • HTD3540/HTD3570: 2.56 kg/each Cable length (front): • HTD3510: 2.2 m • HTD3540/HTD3570: 3.25 m Cable length (rear): 7.
Sound No sound from home theater speakers. • Connect the audio cable from your home theater to your TV or other devices (see 'Connect audio from TV and other devices' on page 9). • Reset your home theater to its factory settings (see 'Restore default settings' on page 19), then switch it off and switch on again. • On your home theater, press SOURCE repeatedly to select the correct audio input. Distorted sound or echo. • If you play audio from the TV through the home theater, make sure that the TV is muted.
9 Notice This section contains the legal and trademark notices. Copyright This item incorporates copy protection technology that is protected by U.S. patents and other intellectual property rights of Rovi Corporation. Reverse engineering and disassembly are prohibited. Trademarks Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories.
10 Language code Abkhazian 6566 Afar 6565 Afrikaans 6570 Amharic 6577 Arabic 6582 Armenian 7289 Assamese 6583 Avestan 6569 Aymara 6589 Azerhaijani 6590 Bahasa Melayu 7783 Bashkir 6665 Belarusian 6669 Bengali 6678 Bihari 6672 Bislama 6673 Bokmål, Norwegian 7866 Bosanski 6683 Brezhoneg 6682 Bulgarian 6671 Burmese 7789 Castellano, Español 6983 Catalán 6765 Chamorro 6772 Chechen 6769 Chewa; Chichewa; Nyanja 7889 9072 Ё᭛ Chuang; Zhuang 9065 Church Slavic; Slavonic 6785 Chuvash 6786 Corsican 6779 Česky 6783 Dansk
11 Index A amplifier audio predefined modes specifications audio options L language language code 21 16 21 13 C care product connectors front connectors control disc play main unit 3 5 12 4 D discs audio options control buttons options play synchronize picture and sound time search titles display VCD/SVCD menu display panel F FM antenna 13 12 13 11 12 13 13 12 4 6 H HDMI K karaoke 26 EN 15 25 M main unit overview specifications troubleshooting media formats MP3 connector 4 21 22 20 5
S safety use of the product sound predefined sound mode surround sound synchronize picture and sound troubleshooting sound mode speakers specifications surround sound subwoofer specifications synchronize picture and sound T time search titles trademarks troubleshooting connection main unit picture play sound tuning grid 2 16 16 12 23 16 21 16 21 12 13 13 24 22 22 22 23 23 15 U USB format USB storage device options specifications 21 13 21 V video synchronize picture and sound video formats video op
Specifications are subject to change without notice © 2013 Koninklijke Philips Electronics N.V. All rights reserved. HTD3510/3540/3570_51_UM_V1.