Always there to help you Register your product and get support at www.philips.
Contents 1 Important Safety Care for your product Care of the environment Copyright Compliance 2 Your home theater Main unit Remote control Connectors 2 2 3 3 3 4 7 Product specifications 20 8 Troubleshooting 22 9 Language code 24 4 4 4 6 10 Index 25 3 Connect and set up 7 Connect speakers 7 Connect to TV 8 Connect audio from TV and other devices 9 Set up speakers 10 Set up EasyLink (HDMI-CEC control) 10 4 Use your home theater 12 12 13 14 14 15 15 16 5 Change settings 16 16 17 17 17 18 18
1 Important Read and understand all instructions before you use your home theater. If damage is caused by failure to follow instructions, the warranty does not apply. Safety Risk of electric shock or fire! • Never expose the product and accessories to rain or water. Never place liquid containers, such as vases, near the product. If liquids are spilt on or into the product, disconnect it from the power outlet immediately. Contact Philips Consumer Care to have the product checked before use.
Risk of swallowing batteries! • The product/remote control may contain a coin/button type battery, which can be swallowed. Keep the battery out of reach of children at all times! If swallowed, the battery can cause serious injury or death. Severe internal burns can occur within two hours of ingestion. • If you suspect that a battery has been swallowed or placed inside any part of the body, seek immediate medical attention.
Compliance This product complies with the radio interference requirements of the European Community. 2 Your home theater Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your home theater at www.philips.com/welcome. Main unit a Disc compartment b Display panel c (Open/Close) Open or close the disc compartment. d (Play/Pause) Start, pause or resume play. e SOURCE Select an audio or video source for the home theater.
AUDIO SOURCE: Select an audio input source. RADIO: Switch to FM radio. USB: Switch to USB storage device. • • • a q p b o c d n e c Navigation buttons • Navigate menus. • In video mode, press left or right to fast backward or fast forward; press up or down to slow forward or slow backward. • In radio mode, press left or right to search a radio station; press up or down to fine tune a radio frequency. d OK Confirm an entry or selection. e BACK Return to a previous menu screen.
o (Open/Close) Open or close the disc compartment. p (Home) Access the home menu. q AUDIO SYNC • Select an audio language or channel. • Press and hold to access audio delay setting, then press Navigation buttons (left/right) to delay the audio to match the video. Connectors This section includes an overview of the connectors available on your home theater. Front a (USB) Audio, video or picture input from a USB storage device. b AUDIO IN Audio input from an MP3 player (3.5mm jack).
3 Connect and set up SUB WOOFER FRONT LEFT FRONT CENTER FRONT RIGHT This section helps you connect your home theater to a TV and other devices, and then set it up. For information about the basic connections of your home theater and accessories, see the quick start guide. Note REAR LEFT REAR RIGHT •• For identification and supply ratings, see the type plate at the back or bottom of the product.
4 5 REAR LEFT (rear left) and REAR RIGHT (rear right) speakers: Place the rear surround speakers to the left and right side of your seating position, either in line with it or slightly behind it. 2 SUBWOOFER (subwoofer): Place the subwoofer at least one meter to the left or right of the TV. Leave about 10-centimeter clearance from the wall. On your TV, turn on HDMI-CEC operations. For details, see the TV user manual.
4 connected through HDMI to be controlled by a single remote control, such as volume control for both the TV and the home theater. (see 'Set up EasyLink (HDMI-CEC control)' on page 10) If you cannot hear the TV audio through your home theater, set up the audio manually. (see 'Set up the audio' on page 11) Note •• If your TV has a DVI connector, you can use an HDMI/ DVI adapter to connect to TV. However, some of the features may not be available.
Option 2: Connect audio through analog audio cables Basic quality audio AUDIO IN- AUX VCR Set up EasyLink (HDMI-CEC control) This home theater supports Philips EasyLink, which uses the HDMI-CEC (Consumer Electronics Control) protocol. EasyLinkcompliant devices that are connected through HDMI can be controlled by a single remote control. Note 1 Using an analog cable, connect the AUX connectors on your home theater to the AUDIO OUT connectors on the TV or other device.
EasyLink controls With EasyLink, you can control your home theater, TV, and other connected HDMI-CEC compliant devices with a single remote control. • [One Touch Play] (One-touch play): If onetouch play is enabled, press (StandbyOn) on the remote control of your home theater to wake up the TV from standby. • [One Touch Standby] (One-touch standby): If one-touch standby is enabled, your home theater can switch to standby with the remote control of the TV or other HDMI-CEC devices.
4 Use your home theater This section helps you use the home theater to play media from a wide range of sources. Before you start • Make the necessary connections described in the Quick start guide and the user manual. • Switch the TV to the correct source for the home theater. 1 2 3 Press (Home). »» The home menu is displayed. Press the Navigation buttons and OK to select the following: • [DISC]: Start disc play. • [USB]: Access the USB content browser.
Display menu for VCD and SVCD Display the content menu on VCD and SVCD discs. 1 2 3 Press (Home). Select [Setup], and then press OK. Select [Preferences] > [PBC]. • [PBC]: Enable or disable the content menu navigation of VCD and SVCD discs with Play Back Control feature. Data files Your home theater can play pictures, audio and video files contained in a disc or a USB storage device. Before you play a file, check that the file format is supported by your home theater (see 'File formats' on page 20).
USB storage devices Enjoy pictures, audio, and video stored on a USB storage device such as an MP4 player or digital camera. What you need • A USB storage device that is formatted for FAT or NTFS file system, and complies with the Mass Storage Class. • A media file in one of the supported file formats. (see 'File formats' on page 20) Video options 1 2 Note •• If you use a USB extension cable, USB HUB or USB multi-reader, the USB storage device may not be recognized.
4 5 Press to stop slideshow. Press again to stop music. Button Action RADIO Manual: 1) In radio mode, press RADIO. 2) When a radio frequency blinks, press OK to store the radio station. 3) Repeat step 1 and 2 to store other stations. Automatic: In radio mode, press and hold RADIO for three seconds to reinstall all the available radio station. Radio Listen to FM radio on your home theater, and store up to 40 radio stations. Note •• AM and digital radio are not supported.
Choose sound This section helps you choose the ideal sound for your video or music. Sound mode 5 Change settings The home theater settings are already configured for optimal performance. Unless you have a reason to change a setting, we recommend that you keep the default setting. Select predefined sound modes to suit your video or music. 1 Press SOUND repeatedly to select a sound mode. • MOVIE: Enjoy a cinematic audio experience, specially enhanced for movies.
Picture and video settings 1 2 3 Press 3 (Home). Select [Setup] and then press OK. Select [Video] and then press OK. • [TV System]: Select a video format supported by the TV. • [TV Display]: Select a picture format to fit the TV screen. • [Picture Setting]: Select animation for the slide show. • [HD JPEG]: Enable this feature to view high-definition JPEG pictures through HDMI connection. • [HDMI Setup]: Access the following setup through HDMI connection.
3 Select [General] and then press OK. • [Disc Lock]: Lock the disc to restrict play. You can lock up to 20 discs on your home theater. Note •• To play a locked disc, follow the onscreen instructions to enter the password, and then press OK. Display settings 1 2 3 Press (Home). Select [Setup] and then press OK. Select [Preferences] and then press OK. • [PBC]: Enable or disable the content menu navigation of VCD and SVCD discs with Play Back Control feature. Energy saving settings 1 2 3 Press (Home).
6 Update software Philips continually tries to improve its products. To get the best features and support, update your home theater with the latest software. Compare the version of your current software with the latest version on www.philips.com/support. If the current version is lower than the latest version available on the Philips support website, upgrade your home theater with the latest software. Caution •• Do not install a lower version of software than the current version installed on your product.
7 Product specifications Note •• Specifications and design are subject to change without Amplifier • • • • notice. Video Region codes The type plate on the back or bottom of the home theater shows which regions it supports.
Main unit • • • • • Power supply: • Europe/China/Russia/India: 220-240V~, 50 Hz • Latin America/Asia Pacific: 110-240V~, 50-60 Hz Power consumption: 50 W Standby power consumption: ≤ 0.5 W Dimensions (WxHxD): 360 x 58 x 325 mm Weight: 2.3 kg Subwoofer • • • • • • Output power: 50 W RMS (30% THD) Impedance: 8 ohm Speaker drivers: 133 mm (5.25") woofer Dimensions (WxHxD): 160 x 265 x 265 mm Weight: 2.50 kg Cable length: • HTD3510: 2.3 m • HTD3540/HTD3570: 3.
8 Troubleshooting Warning •• Risk of electric shock. Never remove the casing of the product. To keep the warranty valid, never try to repair the product yourself. If you have problems using this product, check the following points before you request service. If you still have a problem, get support at www.philips.com/support. Main unit The buttons on the home theater do not work. • Disconnect the home theater from the power supply for a few minutes, then reconnect. Picture No picture.
• Select the correct character set (see 'Subtitles' on page 13). Cannot read the contents of a USB storage device. • Make sure that the format of the USB storage device is compatible with the home theater. • Make sure that the file system on the USB storage device is supported by the home theater. 'input invalid' or 'x' sign appears on the TV. • The operation is not possible. EasyLink does not work.
9 Language code Abkhazian 6566 Afar 6565 Afrikaans 6570 Amharic 6577 Arabic 6582 Armenian 7289 Assamese 6583 Avestan 6569 Aymara 6589 Azerhaijani 6590 Bahasa Melayu 7783 Bashkir 6665 Belarusian 6669 Bengali 6678 Bihari 6672 Bislama 6673 Bokmål, Norwegian 7866 Bosanski 6683 Brezhoneg 6682 Bulgarian 6671 Burmese 7789 Castellano, Español 6983 Catalán 6765 Chamorro 6772 Chechen 6769 Chewa; Chichewa; Nyanja 7889 9072 Ё᭛ Chuang; Zhuang 9065 Church Slavic; Slavonic 6785 Chuvash 6786 Corsican 6779 Česky 6783 Dansk
10 Index A amplifier audio predefined modes specifications audio options L language language code 20 16 20 14 C care environment product connectors front connectors control disc play main unit 3 3 6 12 4 D discs audio options control buttons options play synchronize picture and sound time search titles display VCD/SVCD menu display panel F FM antenna H HDMI 24 M main unit overview specifications troubleshooting media formats MP3 connector 4 21 22 20 6 O options picture overview main unit r
S safety disposal use of the product sound predefined sound mode surround sound synchronize picture and sound troubleshooting sound mode speakers specifications surround sound subwoofer specifications synchronize picture and sound T time search titles troubleshooting connection main unit picture play sound tuning grid 3 2 16 16 12 22 16 21 16 21 12 14 14 22 22 22 22 22 15 U USB format USB storage device options specifications 20 14 20 V video synchronize picture and sound video formats video optio
Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories. DivX , DivX Ultra , DivX Certified and associated logos are trademarks of Rovi Corporation or its subsidiaries and are used under license. DivX Ultra Certified to play DivX video with advanced features and premium content. ABOUT DIVX VIDEO: DivX is a digital video format created by DivX, LLC, a subsidiary of Rovi Corporation.
Specifications are subject to change without notice © 2014 Koninklijke Philips N.V. All rights reserved. Trademarks are the property of Koninklijke Philips N.V. or their respective owners. HTD3510/3540/3570_12_UM_V3.
