Always there to help you Register your product and get support at www.philips.
Contents 1 Important Safety Care for your product Care of the environment 2 Your home theater Main unit Remote control Connectors 2 2 3 3 4 4 4 5 7 Product specifications 22 8 Troubleshooting 24 9 Notice Copyright Trademarks 26 26 26 10 Language code 27 3 Connect and set up 7 Connect speakers 7 Connect to TV 8 Connect audio from TV and other devices 9 Set up speakers 10 Set up EasyLink (HDMI-CEC control) 10 4 Use your home theater
1 Important Read and understand all instructions before you use your home theater. If damage is caused by failure to follow instructions, the warranty does not apply. Safety Risk of electric shock or fire! • Never expose the product and accessories to rain or water. Never place liquid containers, such as vases, near the product. If liquids are spilt on or into the product, disconnect it from the power outlet immediately. Contact Philips Consumer Care to have the product checked before use.
• • • of children at all times! If swallowed, the battery can cause serious injury or death. Severe internal burns can occur within two hours of ingestion. If you suspect that a battery has been swallowed or placed inside any part of the body, seek immediate medical attention. When you change the batteries, always keep all new and used batteries out of reach of children. Ensure that the battery compartment is completely secure after you replace the battery.
2 Your home theater Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your home theater at www.philips.com/welcome. Main unit Load Pause Mute Remote control This section includes an overview of the remote control. a q b p o a Disc compartment b Display panel c c (Open/Close) Open or close the disc compartment, or eject the disc. d d (Play/Pause) Start, pause or resume play.
a (Standby-On) Switch the home theater on or to standby. • When EasyLink is enabled, press and hold for at least three seconds to switch all connected HDMI CEC compliant devices to standby. • k SURR Select surround sound or stereo sound. l (Play/Pause) Start, pause or resume play. m (Stop) Stop play. b Source buttons • DISC: Switch to disc source.Access or exit the disc menu when you play a disc. • AUDIO SOURCE: Select an audio input source. • RADIO: Switch to FM radio.
b MIC Audio input from a microphone. c AUDIO IN Audio input from an MP3 player (3.5mm jack). Back connectors a AC MAINS Connect the supplied AC power cable. b SPEAKERS Connect to the supplied speakers and subwoofer. c VIDEO OUT Connect to the composite video input on the TV. d AUDIO IN-AUX Connect to an analog audio output on the TV or an analog device. e DIGITAL IN-OPTICAL Connect to an optical audio output on the TV or a digital device. f HDMI OUT (ARC) Connect to the HDMI input on the TV.
3 Connect and set up SUB WOOFER FRONT LEFT FRONT CENTER FRONT RIGHT This section helps you connect your home theater to a TV and other devices, and then set it up. For information about the basic connections of your home theater and accessories, see the quick start guide. Note REAR LEFT REAR RIGHT •• For identification and supply ratings, see the type plate at the back or bottom of the product.
5 Place the rear surround speakers to the left and right side of your seating position, either in line with it or slightly behind it. • SUBWOOFER (subwoofer): Place the subwoofer at least one meter to the left or right of the TV. Leave about 10-centimeter clearance from the wall. 3 Connect to TV Connect your home theater to a TV to watch videos. You can listen to the TV audio through your home theater speakers. Use the best quality connection available on your home theater and TV.
4 TV and the home theater. (see 'Set up EasyLink (HDMI-CEC control)' on page 10) If you cannot hear the TV audio through your home theater, set up the audio manually. (see 'Set up the audio' on page 11) Note •• If your TV has a DVI connector, you can use an HDMI/ DVI adapter to connect to TV. However, some of the features may not be available. 4 When you watch videos, switch your TV to the correct video input. For details, see the TV user manual.
Option 2: Connect audio through analog audio cables Basic quality audio AUDIO IN- AUX VCR Set up EasyLink (HDMI-CEC control) This home theater supports Philips EasyLink, which uses the HDMI-CEC (Consumer Electronics Control) protocol. EasyLinkcompliant devices that are connected through HDMI can be controlled by a single remote control. Note 1 Using an analog cable, connect the AUX connectors on your home theater to the AUDIO OUT connectors on the TV or other device.
EasyLink controls With EasyLink, you can control your home theater, TV, and other connected HDMI-CEC compliant devices with a single remote control. • [One Touch Play] (One-touch play): If onetouch play is enabled, press (StandbyOn) on the remote control of your home theater to wake up the TV from standby. • [One Touch Standby] (One-touch standby): If one-touch standby is enabled, your home theater can switch to standby with the remote control of the TV or other HDMI-CEC devices.
4 Use your home theater This section helps you use the home theater to play media from a wide range of sources. Before you start • Make the necessary connections described in the Quick start guide and the user manual. • Switch the TV to the correct source for the home theater. Access the home menu The home menu provides easy access to connected devices, setup and other useful features in your home theater. 1 2 3 Press (Home). »» The home menu is displayed.
Note Note •• Picture and sound can be synchronized through the setup menu, press > [Audio Sync]. (Home), select [Setup] > [Audio] Display menu for VCD and SVCD Display the content menu on VCD and SVCD discs. 1 2 3 Press (Home). Select [Setup], and then press OK. Select [Preferences] > [PBC]. • [PBC]: Enable or disable the content menu navigation of VCD and SVCD discs with Play Back Control feature.
USB storage devices 2 Enjoy pictures, audio, and video stored on a USB storage device such as an MP4 player. What you need • A USB storage device that is formatted for FAT or NTFS file system, and complies with the Mass Storage Class. • A media file in one of the supported file formats. (see 'File formats' on page 22) Note •• If you use a USB extension cable, USB HUB or USB multi-reader, the USB storage device may not be recognized.
Musical slideshow Play buttons If the picture and audio files are from the same disc or USB storage device, you can create a musical slideshow. Button Action / or Alphanumeric buttons Navigation buttons Select a preset radio station. 1 2 3 4 5 Select an audio track and then press OK. Press folder. BACK and then go to the picture Select a picture and then press OK to start the slideshow. Press to stop slideshow. Press again to stop music.
1 2 3 Using the 3.5mm stereo audio cable, connect the MP3 player to the AUDIO IN connector on your home theater. • If you use 6.5mm stereo audio cable, connect the MP3 player to your home theater using a 3.5mm - 6.5mm converter jack. • • • Press AUDIO SOURCE repeatedly until AUDIO IN appears on the display panel. Press the buttons on the MP3 player to select and play audio files. Karaoke Play a Karaoke disc on your home theater and sing along with the music. What you need • A Karaoke microphone.
• [Stereo]: Two-channel stereo sound. Ideal for listening to music. Note •• If the audio source is a 2.1 channel. multi-channel mode will output 5-channel stereo sound.
5 Change settings The home theater settings are already configured for optimal performance. Unless you have a reason to change a setting, we recommend that you keep the default setting. Note •• You cannot change a setting that is grayed out. •• To return to the previous menu, press BACK. To exit the menu, press (Home). Language settings Onscreen display language 1 2 3 Press (Home). Select [Setup] and then press OK. Select [General] and then press OK.
Audio settings 1 2 3 Press (Home). Select [Setup] and then press OK. Select [Audio] and then press OK. • [HDMI Audio]: Set the HDMI audio output from your TV, or disable HDMI audio output from the TV. • [Audio Sync]: Set audio delay if audio and video cannot be matched. • [Speaker Setup]: Set up speakers for best surround sound experience. • [Sound Mode]: Select a predefined sound mode to suit your video and music.
Restore default settings 1 2 3 4 20 Press (Home). Select [Setup] and then press OK. Select [Preferences] > [Default], and then press OK. Follow the onscreen message to restore default setting. »» Your home theater is reset to its default settings, except for password, parental control and disc lock settings.
6 Update software Philips continually tries to improve its products. To get the best features and support, update your home theater with the latest software. Compare the version of your current software with the latest version on www.philips.com/ support. If the current version is lower than the latest version available on the Philips support website, upgrade your home theater with the latest software. Caution •• Do not install a lower version of software than the current version installed on your product.
7 Product specifications • • Amplifier • • Note •• Specifications and design are subject to change without notice. • • Region codes The type plate on the back or bottom of the home theater shows which regions it supports. Country DVD Europe, United Kingdom Asia Pacific, Taiwan, Korea • • • • Russia, India Media formats DVD-Video, DVD+R/+RW, DVD-R/-RW, DVD+R/-R DL, CD-R/CD-RW, Audio CD, Video CD/SVCD, Picture files, MP3 media, WMA media, DivX media, USB storage device File formats • Audio: .
• • • Class support: USB Mass Storage Class (MSC) File system: FAT16, FAT32, NTFS USB port: 5V , 500mA • • • Main unit • • • • • Power supply: • Europe/China/Russia/India: 220-240V~, 50 Hz • Latin America/Asia Pacific: 110-240V~, 50-60 Hz Power consumption: 50 W Standby power consumption: ≤ 0.5 W Dimensions (WxHxD): 360 x 58 x 325 mm Weight: 2.3 kg • • • Subwoofer • • • • • • Output power: 50 W RMS (30% THD) Impedance: 8 ohm Speaker drivers: 165 mm (6.
8 Troubleshooting Warning •• Risk of electric shock. Never remove the casing of the product. To keep the warranty valid, never try to repair the product yourself. If you have problems using this product, check the following points before you request service. If you still have a problem, get support at www. philips.com/support. Main unit The buttons on the home theater do not work. • Disconnect the home theater from the power supply for a few minutes, then reconnect. Picture No picture.
DivX subtitles do not display correctly. • Make sure that the subtitle file name is the same as the movie file name (see 'Subtitles' on page 13). • Select the correct character set (see 'Subtitles' on page 13). Cannot read the contents of a USB storage device. • Make sure that the format of the USB storage device is compatible with the home theater. • Make sure that the file system on the USB storage device is supported by the home theater. 'input invalid' or 'x' sign appears on the TV.
9 Notice This section contains the legal and trademark notices. Copyright This item incorporates copy protection technology that is protected by U.S. patents and other intellectual property rights of Rovi Corporation. Reverse engineering and disassembly are prohibited. Trademarks Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories.
10 Language code Abkhazian 6566 Afar 6565 Afrikaans 6570 Amharic 6577 Arabic 6582 Armenian 7289 Assamese 6583 Avestan 6569 Aymara 6589 Azerhaijani 6590 Bahasa Melayu 7783 Bashkir 6665 Belarusian 6669 Bengali 6678 Bihari 6672 Bislama 6673 Bokmål, Norwegian 7866 Bosanski 6683 Brezhoneg 6682 Bulgarian 6671 Burmese 7789 Castellano, Español 6983 Catalán 6765 Chamorro 6772 Chechen 6769 Chewa; Chichewa; Nyanja 7889 9072 Ё᭛ Chuang; Zhuang 9065 Church Slavic; Slavonic 6785 Chuvash 6786 Corsican 6779 Česky 6783 Dansk
11 Index A amplifier audio predefined modes specifications audio options L language language code 22 16 22 14 C care product connectors front connectors control disc play main unit 3 5 12 4 D discs audio options control buttons options play synchronize picture and sound time search titles display VCD/SVCD menu display panel F FM antenna 14 12 14 12 12 14 14 13 4 6 H HDMI K karaoke 28 EN 16 27 M main unit overview specifications troubleshooting media formats MP3 connector 4 23 24 22 5
S safety use of the product sound predefined sound mode surround sound synchronize picture and sound troubleshooting sound mode speakers specifications surround sound subwoofer specifications synchronize picture and sound T time search titles trademarks troubleshooting connection main unit picture play sound tuning grid 2 16 16 12 24 16 23 16 23 12 14 14 26 24 24 24 24 24 15 U USB format USB storage device options specifications 22 14 22 V video synchronize picture and sound video formats video op
Specifications are subject to change without notice © 2013 Koninklijke Philips Electronics N.V. All rights reserved. HTD3510/3540/3570_98_UM_V1.
