User manual

14 EN
6 Wall mount
Note
• Improper wall mounting may result in accident,
injury or damage. If you have any query,
contact Consumer Care in your country.
• Before wall mounting, make sure the wall can
support the weight of your SoundBar.
• Before wall mount, you need not remove
the four rubber feet at the bottom of the
SoundBar, otherwise the rubber feet cannot
be xed back.
Screw length/diameter
Depending on the type of wall
mounting your SoundBar, make sure
that you use screws of a suitable length
and diameter.
See the illustration in the quick start
guide on how to wall mount the
SoundBar.
1) Drill two holes on the wall.
2) Secure the dowels and screws in the
holes.
3) Hang the SoundBar on the fastening
screws.
> 25mm
3.5-4mm
4mm
7 Product
specifications
Note
• Specications and design are subject to
change without notice.
Amplier
• RMS Total output power:
120W RMS (+/- 0.5 dB, 10% THD)
• Frequency response:
20 Hz-20 kHz / ±3 dB
• Signal-to-noise ratio: > 65 dB
(CCIR) / (A-weighted)
• Input sensitivity:
• AUX: 900 mV
Audio
• S/PDIF Digital audio input:
• Coaxial: IEC 60958-3
• Optical: TOSLINK
USB
• Compatibility: Hi-Speed USB (2.0)
• Class support: USB Mass Storage
Class (MSC)
• File system: FAT16, FAT32, NTFS
• Supports MP3 le formats
Bluetooth
• Bluetooth proles: A2DP, AVRCP
• Bluetooth version: 3.0 + EDR
• Frequency band/Output power:
2400 - 2483.5 MHz / ≤ 20 dBm
Wireless speaker link
• Frequency band: 2400 - 2483.5 MHz
• Output power: ≤ 20 dBm