User Manual

1
Placebothfilesin theUSBdriveandsystemwillauto‐detecttherightupgradefile
Software Update Instructions
To get the best features and support, update
your product with the latest software.
What you need
• Connect Soundbar to your TV through HDMI
(recommended non HDMI ARC input)
Note:
• This software update can be completed without connect
ing TV through HDMI but you have to follow the local
display on the soundbar carefully.
Check software version
In HDMI ARC source mode, press TREBLE -,
BASS - and VOLUME - on the remote control.
Check on Sound bar local display for version info
(will show in following sequence)
1) Main Version
2) RISC version
3) TX version
4) RX version
5) Repeater version (if applicable)
Update software via USB
1
Check the latest software version on www.philips.com/
support.
• Search for your model and click on "Software and
drivers".
2
Download the software into a USB storage device.
a. Unzip the downloaded file, and make sure that the unzi
pped file(s) is(are) named the following:
HTL5140 - "HTL5140.BIN"
HTL5145 - "HTL5145.BIN".
*HTL6140 - "HTL6140.BIN" & "HTL6140NW.BIN" &
"HTL6140N.BIN"
*HTL6145 - "HTL6145.BIN" & "HTL6145W.BIN"

b Put the related software file(s) in the
root directory of the USB storage device.
Note for models HTL6140 & HTL6145 (*)
software name (bin file) WITHOUT alphabet “W” is for the
product with serial prefix of PT1Axxxxxxxxx only!
software name (bin file) WITH alphabet “W” is for the pro
duct with serial prefix of PT2Axxxxxxxxx only!
For HTL6140: Unzip all three HTL6140.BIN ,HTL6140N.
BIN and HTL6140NW.BIN files in the USB drive and the
set would auto-detect the correct upgrade file.
For HTL6145: Unzip both HTL6145.BIN and HTL6145W.
BIN files in the USB drive and the set would auto-detect t
he correct upgrade file.
3
Connect the USB storage device to the (USB)
connector on this product.
4
Switch this product to the HDMI ARC source, and
switch your TV to the HDMI source
5
On the remote control, within 6 seconds press MUTE
twice, and VOLUME+ once, then hold down SURROUND
ON.
»» If an upgrade media is detected, on the TV screen you
are prompted to start the update.
On Soundbar local display, message “UPG” will be
shown
»» If an upgrade media is not detected, an error message
is displayed on the TV screen. Make sure that the latest
software of this product is put in the USB storage device.
6 Press MUTE to start the update.
On Soundbar local display, message “UPG” will be
shown,
7
Wait until the update is completed.
On Soundbar local display, it will show “DONE” when
update is completed
»» If the update is complete, the Soundbar will automatic
ally turn off and on again.
8
The update will be completed within 10 minutes
If you cannot complete the update at step 7, please powe
r off the device and unplug the USB storage device. Then
start from steps 3 -7 again.
9 Check the SW version to ensure the SW upgrade is
done successfully
Note
It is recommended that you perform a factory reset after
software upgrade.