Software Upgrade

Software Update Instructions
To get the best features and support, update
your product with the latest software.
Note:
• This software update can be completed without
connecting TV through HDMI but you have to follow
the local display on the soundbar carefully.
Check software version
In HDMI ARC source mode, press TREBLE -, BASS –
and VOLUME - on the remote control.
Check on Sound bar local display for version info (will show
in following sequence)
• Main Unit (MCU)
• HDMI Repeater (RPT)
• TX version
• Subwoofer RX version
• Touch Panel Version
Update software via USB
1
Check the latest software version on
www.philips.com/support
.
Search for your model and click on "Software and
drivers".
2
Download the software into a USB storage device.
a. Create a folder named UPG in the USB drive
b. Unzip the downloaded file
c. Put the unzipped files in the UPG directory of the USB
storage device.
3
Connect the USB storage device to the USB
port on this product.
4
Switch this product to the HDMI ARC source.
5
On the remote control, within 6 seconds press
MUTE twice, and VOLUME+ once, then hold down MOVIE
»» If an upgrade media is detected, on the LED display will
show “UPG”
»» If an upgrade media is not detected, “ERROR” is displayed
on LED display.
Make sure that the latest software of this product is put in the
USB storage device.
6
Wait until the update is completed.
On Soundbar local display, it will show “DONE” when update
is completed.
»» If the update is complete, the Soundbar will automatically
turn off and on again.
7 The update will be completed within 10 minutes
If you cannot complete the update at step 6, please power off
the device and unplug the USB storage device. Then start from
steps 3 - 6 again.
8 Check the SW version to ensure the SW upgrade is done
successfully
Note
It is recommended that you perform a factory reset after
software upgrade.