Owner's Manual

17
English
Option 5: Using an accessory RF
modulator
If your TV has only a single Antenna Input
jack (labeled as 75 ohm or RF In,) you
will need an RF modulator in order to
view the DVD playback on the TV. See
your electronics retailer or contact
Philips for details about RF modulator
availability and operations.
A Use the supplied composite video cable
(yellow) to connect the DVD system’s
CVBS jack to the video input jack on the
RF modulator.
B Use an RF coaxial cable (not supplied) to
connect ANTENNA OUT to TO TV jack
on the RF modulator to the ANTENNA
IN jack on the TV.
C Connect the Antenna or Cable TV
service signal to the ANTENNA IN or RF
IN jack on the RF modulator. (It may
have been connected to your TV
previously. Disconnect it from the TV.)
Step 4: Connecting the FM/
AM antennas
A Connect the supplied AM loop antenna
to the AM jack. Place the AM loop
antenna on a shelf, or attach it to a stand
or wall.
B Connect the supplied FM antenna to the
FM jack. Extend the FM antenna and  x
its ends to the wall.
For better FM stereo reception, connect
an external FM antenna (not supplied.)
Helpful Hints:
– Adjust the position of the antennas for
optimal reception.
– Position the antennas as far away as
possible from your TV, VCR or other
radiation source to prevent any unwanted
interference.
TIPS: Before making or changing any connections, make sure that all the devices are disconnected
from the power outlet.
Basic Connections (continued)
FM 75
AM
FM/AM ANTENNA
~
MAINS
R
L
1
2
 x the claw
into the slot
FM antenna
AM
antenna
FM 75
AM
FM/AM ANTENNA
~
MAINS
R
L
T
Antenna
Rear of an RF modulator
(example only)
Option 5