User manual
Table Of Contents
- IMPORTANT SAFEGUARDS
- Introduction
- Intended Use
- Your Philips Sonicare Power Flosser
- Nozzles
- Modes and intensities
- Getting Started
- Using your Cordless Power Flosser
- Charging
- Cleaning
- Storage
- Replacement
- Frequently asked questions
- Warranty and support
- PRECAUCIONES IMPORTANTES
- Introducción
- Uso indicado
- Limpiador dental eléctrico Philips Sonicare Power Flosser
- Boquillas
- Modos e intensidades
- Antes de empezar
- Utiliza el limpiador dental eléctrico Cordless Power Flosser
- Carga
- Limpieza
- Almacenamiento
- Sustitución
- Preguntas frecuentes
- Garantía y asistencia
- MISES EN GARDE IMPORTANTES
- Introduction
- Utilisation prévue
- Votre Philips Sonicare Power Flosser
- Les buses
- Modes et intensités
- Premiers pas
- Chargement de votre Cordless Power Flosser
- Charge en cours
- Nettoyage
- Rangement
- Remplacement
- Foire aux questions
- Garantie et assistance
18
English
Cleaning Orthodontic Brackets with the Quad Stream
Nozzle
1 To clean around orthodontic brackets, place
the nozzle tip over each bracket.
2 Gently rotate the nozzle tip around the
bracket in a small circle before moving to
the bracket on the next tooth.
After each use
1 Turn off the Cordless Power Flosser.
2 Detach and Empty the reservoir
3 Remove the nozzle from the handle by
pushing the nozzle release button on the
top of the handle
4 Rinse the nozzle under the tap
5 Dry any excess water from the nozzle, the
outside of the handle, and the reservoir
6 Insert the nozzle back into the handle or
utilize the in-reservoir nozzle storage
feature (see 'Storage').
Note: To facilitate drying, keep the reservoir
side fill port door open or leave the Cordless
Power Flosser disassembled between uses.