operation manual

Preparing for use
Attaching the brush head
1
Align the brush head so the bristles face the front of the handle. (Fig. 4)
2 Firmly press the brush head down on the metal shaft until it stops.
Charging your Philips Sonicare
1 Put the mains plug of the charger or sanitiser in the wall socket.
2 Place the handle on the charger or sanitiser (Fig. 5).
, The ashing light of the battery gauge indicates that the toothbrush
is charging.
- 1 solid green LED indicates that the toothbrush is 34-66% charged.
- 2 solid green LEDs indicate that the toothbrush is 67-94% charged.
- 3 solid green LEDs indicate that the toothbrush is fully charged.
Note: If the battery charge of your Philips Sonicare is low, you hear 3 beeps
and 1 LED of the recharge gauge ashes yellow for 30 seconds after
completing the brushing cycle.
Note: To keep the battery fully charged at all times, you may keep your Philips
Sonicare on the charger when not in use. Once the Philips Sonicare is fully
charged, the charger draws minimal energy from the wall socket.
Note: It takes at least 24 hours to fully charge the battery.
Using the Philips Sonicare
Brushing instructions
1 Wet the bristles and apply a small amount of toothpaste.
2 Place the toothbrush bristles against the teeth at a slight angle
towards the gumline (Fig. 6).
3 Press the power on/off button to switch on the Philips Sonicare.
4 Apply light pressure to maximise Philips Sonicare’s effectiveness and
let the Philips Sonicare toothbrush do the brushing for you. Do not
scrub.
ENGLISH 9
4235_021_4216_1_DFU-SImple_A6_v5.indd 9 24/11/17 13:32