USB Monitor User Manual I1659FWUX www.aoc.com 6 AOC. All Rights Reserved.
Safety........................................................................................................................................................................ 3 National Conventions ......................................................................................................................................... 3 Installation..........................................................................................................................................................
Safety National Conventions The following subsections describe notational conventions used in this document. Notes, Cautions, and Warnings Throughout this guide, blocks of text may be accompanied by an icon and printed in bold type or in italic type. These blocks are notes, cautions, and warnings, and they are used as follows: NOTE: A NOTE indicates important information that helps you make better use of your computer system.
Installation Do not place the monitor on an unstable cart, stand, tripod, bracket, or table. If the monitor falls, it can injure a person and cause serious damage to this product. Use only a cart, stand, tripod, bracket, or table recommended by the manufacturer or sold with this product. Follow the manufacturer‟s instructions when installing the product and use mounting accessories recommended by the manufacturer. A product and cart combination should be moved with care.
Cleaning Clean the cabinet regularly with cloth. You can use soft-detergent to wipe out the stain, instead of strong-detergent which will cauterize the product cabinet. When cleaning, make sure no detergent is leaked into the product. The cleaning cloth should not be too rough as it will scratch the screen surface.
Other If the product is emitting a strange smell, sound or smoke, disconnect the power plug IMMEDIATELY and contact a Service Center. Make sure that the ventilating openings are not blocked by a table or curtain. Do not engage the USB Monitor in severe vibration or high impact conditions during operation. Do not knock or drop the monitor during operation or transportation.
Setup Contents of the box Monitor * CD Manual Carry Case (Option) 7 USB Cable
Setup Stand Please setup the stand following the steps as below. Setup: Caution: Must put unit on a flat surface. Any uneven or sloped surface may result in unit damage or injury to user.
Adjusting Viewing Angle For optimal viewing, it is recommended to look at the full face of the monitor, and then adjust the monitor's angle to your own preference. Hold the stand so you will not topple the monitor when you change the monitor's angle. You are able to adjust the monitor's angle as below. NOTE: Do not touch the LCD screen when you change the angle. It may cause damage or break the LCD screen.
Connecting the Monitor Cable Connections In Rear of Monitor to Connect PC/Notebook/Laptop: Important!! Follow the software installation described on page 11 to 14 before connecting the USB monitor to your Notebook/Laptop/PC. 1 Connecting the USB Monitor to your computer To protect the equipment, always turn off the computer before connecting. - Connect one end of the USB cable to the USB Monitor and the other end of USB cable to the computer. - Your computer should detect the USB Monitor automatically.
Installation of USB Graphic software on your computer For Microsoft ® Windows® 8 Important!! Install the USB Graphic software first before connecting the USB monitor to your computer. Windows 8 DisplayLink software can be installed from Windows update. Alternatively, the software can be downloaded from the DisplayLink website following the steps below. 1. Double click on Setup.exe. The Windows User Account Control window opens (if enabled in the OS). 2. Click Yes.
4. Connect your DisplayLink device via the USB cable to your PC. A message will be shown that DisplayLink software is configuring itself for first use. 5. The screen should flash and the DisplayLink device should start to extend the Windows desktop. Note: You may need to reboot the computer before you use the DisplayLink enabled device. For Microsoft ® Windows® 7 Important!! Install the USB Graphic software first before connecting the USB monitor to your computer. 1. Double click on Setup.exe.
3. Click I Accept. DisplayLink Core software and DisplayLink Graphics installs. Note: The screen may flash or go black during the installation. The installation box above will disappear but no message will be shown at the end of the installation. 4. Connect your AOC USB Monitor via the USB cable to your PC/Notebook. Installing device driver message will be shown on the taskbar. The Windows User Account control window opens. 5. Click YES. DisplayLink will automatically install the AOC USB Monitor.
Setting the USB Monitor Follow this procedure to configure the AOC Monitor 1. Open screen resolution 2. Set the display options. Refer to the table below for details on each option. Menu Sub-Menu Description Display Use the drop down list to select a display to be configured.
To Control the Display You can use the AOC USB USB Monitor in mirror mode or extended mode. Settings may vary depending on your operating system. For Microsoft® Windows® 8 and Microsoft® Windows® 7 Press the Windows® key ( Right-click the “ ) + P to switch between different modes as shown below. ”icon in the system tray of your Windows ® desktop to configure the display settings. MENU Displaylink Manager Sub-menu Opens the Resolution window.
Disconnecting the USB Monitor Remove the USB cable from the computer and monitor. Cleaning the USB Monitor Please follow the guidelines below when cleaning the USB Monitor: - Always unplug the monitor before cleaning. - Use a soft cloth to wipe the screen and other parts of the monitor - Never spray liquids directly onto the LCD screen or use harsh chemical products to clean it.
Media Playback On Windows 8, Windows 7, Windows 10, the DisplayLink USB Graphic device can display media files and DVDs using the following media players: Windows Media Player 12 (http://www.microsoft.com/windows/windowsmedia/default.mspx) Windows Media Player 11 (http://www.microsoft.com/windows/windowsmedia/default.mspx) WinDVD 11 (www.intervideo.com) PowerDVD 12 (www.cyberlink.com) The DisplayLink USB Graphics device can display media files and DVDs using most media players.
Windows 7 , Windows 8 and Windows 10 For Windows 7 , Windows 8 and Windows 10, the Windows Experience Index (WEI) is a useful measure of hardware level. The WEI is accessible from Computer > Properties, or from Control Panel > System. The recommended typical hardware requirements for the PC are: WEI score of at least 3 in the „Graphics; Desktop performance for Windows Aero‟ category. Overall WEI score of at least 3 as recommended by Microsoft. At least one USB 2.0 port.
Graphics Card Support (Windows 8/Windows 7/Windows 10) On Windows 8, Windows 7 and Windows 10, DisplayLink software interacts closely with the primary graphics card. DisplayLink support and test a single graphics card (GPU) installed in a PC from all major GPU vendors (Intel, ATI, NVidia and Via). SIS graphic cards are not supported.
Troubleshooting This section provides tips for correcting problems, should any occur. It also describes how to contact AOC should you encounter problems that you cannot resolve. Before you call AOC service center, please read the troubleshooting advice in this manual and in your computer User's Manual. You may also want to consult with your system administrator or company technical support staff. Problem & Question Possible Solutions Check the connectors.
Specification General Specification Panel Resolution Model name I1659FWUX Driving system TFT Color LCD Viewable Image Size 39.49cm diagonal Pixel pitch 0.17925(H)mm x 0.17925(V)mm Display Color 262K Colors Dot Clock 148.5MHz Horizontal scan range 48kHz Horizontal scan Size(Maximum) 344.16mm Vertical scan range 60Hz Vertical scan Size(Maximum) 193.59mm Optimal preset resolution 1920×1080@60Hz Plug & Play VESA DDC2B Input Connector USB 3.
FACTORY PRESENT TIMING TABLE STANDARD RESOLUTION HORIZONTAL FREQUENCY(kHz) VERTICAL FREQUENCY(Hz) VGA 640x480 31.469 59.94 SVGA 800x600 37.879 60.317 XGA 1024x768 48.363 60.004 SXGA 1920x1080 67.5 60 Regulation FCC Notice FCC Class B Radio Frequency Interference Statement WARNING: (FOR FCC CERTIFIED MODELS) NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
WEEE Declaration Disposal of Waste Equipment by Users in Private Household in the European Union. This symbol on the product or on its packaging indicates that this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment.
EPA Energy Star ENERGY STAR® is a U.S. registered mark. As an ENERGY STAR® Partner, AOC International (Europe) BV and Envision Peripherals, Inc. have determined that this product meets the ENERGY STAR® guidelines for energy efficiency.
Service Warranty Statement for Europe LIMITED THREE-YEAR WARRANTY* For AOC LCD Monitors sold within Europe, AOC International (Europe) B.V. warrants this product to be free from defects in material and workmanship for a period of Three (3) years after the original date of consumer purchase. During this period, AOC International (Europe) B.V. will, at its option, either repair the defective product with new or rebuilt parts, or replace it with a new or rebuilt product at no charge except as *stated below.
All AOC LCD Monitors are produced according to the ISO 9241-307 Class 1 pixel policy standards. If your warranty has expired, you still have access to all available service options, but you will be responsible for the cost of service, including parts, labor, shipping (if any) and applicable taxes. AOC Certified or Authorized Service Center will provide you with an estimate of service costs before receiving your authorization to perform service.
Warranty Statement for Middle East and Africa (MEA) And The Commonwealth of Independent States (CIS) LIMITED ONE to THREE YEARS WARRANTY* For AOC LCD Monitors sold within the Middle East and Africa (MEA) and the Commonwealth of Independent States (CIS), AOC International (Europe) B.V. warrants this product to be free from defects in material and workmanship for a period of One (1) to Three (3) years from the manufacture date depending on sale country. During this period, AOC International (Europe) B.V.
Repair, modification, or installation of options or parts by anyone other than an AOC Certified or Authorized Service Center Improper environments like humidity, water damage and dusts Damaged by violence, earthquakes and terrorist attacks Excessive or inadequate heating or air conditioning or electrical powers failures, surges, or other irregularities This limited warranty does not cover any of the product firmware or hardware that you or any third party have modified or altered; you bear t
AOC International (Europe) B.V. Prins Bernhardplein 200 / 6th floor, Amsterdam, The Netherlands Tel: +31 (0)20 504 6962 • Fax: +31 (0)20 5046933 AOC Pixel Policy ISO 9241-307 Class 1 July 25th, 2013 AOC strives to deliver the highest quality products. We use some of the industry’s most advanced manufacturing processes and practice stringent quality control. However, pixel or sub pixel defects on the TFT monitor panels used in flat panel monitors are sometimes unavoidable.
Warranty Statement for North & South America (excluding Brazil) WARRANTY STATEMENT for AOC Color Monitors Including those Sold within North America as Specified Envision Peripherals, Inc. warrants this product to be free from defects in material and workmanship for a period of three (3) years for parts & labor and one (1) year for CRT Tube or LCD Panel after the original date of consumer purchase. During this period, EPI ( EPI is the abbreviation of Envision Peripherals, Inc.
ALL EXPRESS AND IMPLIED WARRANTIES FOR THIS PRODUCT (INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE) ARE LIMITED IN DURATION TO A PERIOD OF THREE (3) YEARS FOR PARTS AND LABOR AND ONE (1) YEAR FOR CRT TUBE OR LCD PANEL FROM THE ORIGINAL DATE OF CONSUMER PURCHASE. NO WARRANTIES (EITHER EXPRESSED OR IMPLIED) APPLY AFTER THIS PERIOD.
