Always there to help you Register your product and get support at www.philips.
Contents 1 Important Safety 2 2 2 Your Micro Hi-Fi System 4 3 Get started 8 Introduction What's in the box Overview of the main unit Overview of the remote control Connect speakers Connect power Prepare the remote control Set clock Turn on 5 Listen to radio 12 6 Other features 13 7 Product information 14 8 Troubleshooting 16 Set the alarm timer Set the sleep timer Listen through headphone Specifications Maintenance 17 17 17 8 8 8 9 9 10 Tune to an FM/AM radio station Program radio stati
1 Important • • Safety This 'bolt of lightning' indicates uninsulated material within the device may cause an electrical shock. For the safety of everyone in your household, please do not remove the covering. The 'exclamation mark' calls attention to features for which you should read the enclosed literature closely to prevent operating and maintenance problems.
• Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Warning •• Never remove the casing of this apparatus. •• Never lubricate any part of this apparatus. •• Never place this apparatus on other electrical equipment. •• Keep this apparatus away from direct sunlight, naked flames or heat. •• Never look into the laser beam inside the apparatus.
2 Your Micro HiFi System Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.Philips.com/welcome.
Overview of the main unit a b c h d i e f j k l m g EN 5
a PULL TO OPEN • Open or close the disc compartment. b STANDBY-ON • Turn on the micro system. • Switch the system to standby mode. c iR • Receive infrared signals from the remote control. d SOURCE • Select a source: disc, tuner, tape or AUX (external audio source). e PRESET +/• Select a preset radio station. m PULL TO OPEN • Open the tape button cover. Overview of the remote control g a b c h i d j f DBB • Turn dynamic bass enhancement on or off. g Tape deck operation • Start tape play.
e PROG • Program tracks. • Program radio stations. f PRESET +/• Select a preset radio station. g POWER • Turn on the micro system. • Switch the micro system to standby mode. h SLEEP • Set the sleep timer. i CLOCK/DISPLAY • Set the clock. • Display play information. j TIMER • Set the alarm timer. k • Start or pause play. / • Search within a track or disc. • Tune to a radio station. / • Skip to the previous or next track. l DBB • Turn dynamic bass enhancement on or off. m • Stop play or erase a program.
3 Get started Always follow the instructions in this chapter in sequence. Connect speakers To insert each speaker wire: 1 2 3 Hold down the socket flap. Insert the speaker wire fully. Release the socket flap. Connect power Caution •• Risk of product damage! Make sure that the power supply voltage corresponds to the voltage printed on the back of the micro system. •• Before connecting the AC power cord, make sure that you have completed all other connections.
3 Close the battery compartment. Turn on Press POWER. »» The micro system switches to the last selected source. Switch to standby mode Note •• Batteries contain chemical substances, so they should be disposed of properly. Press POWER to switch the system to standby mode. »» The backlight on the display panel is dimmed. »» The clock (if set) appears on the display panel. Set clock 1 2 3 4 5 6 7 8 Press POWER to switch the system to standby mode. »» --:-- (or clock) is displayed.
4 Play Repeat play 1 Play a disc Note •• Make sure that the disc contains playable audio content. 1 On the top panel, pull up to open the disc compartment. 2 Insert a disc with the printed side facing up, then close the disc compartment. 2 During play, select a repeat play mode: • To play the current track repeatedly, press REPEAT on the main unit. • To play all tracks repeatedly, press REP ALL on the remote control. To return to normal play, press REPEAT or REP ALL again.
• Play a tape • the AUX socket on the micro system, and the headphone socket on an external device. AUX PULL TO OPEN 1 2 3 4 5 2 3 Press TAPE to select the tape source. On the front panel, pull at the PULL TO OPEN position to open the tape button cover. Press to open the tape door. Load a tape with the open side downward, and then close the tape door. Press to start play. • To pause or resume tape play, press . • To stop tape play, press . • To fast rewind or wind the tape, press / .
5 Listen to radio Tune to an FM/AM radio station Tip Program radio stations manually Note •• You can program a maximum of 40 preset radio stations. •• To overwrite a programmed radio station, store another station in its place. •• For better reception, fully extend and adjust the position of the antenna. 1 2 3 Press TUN to select radio source. Press and hold / until the frequency starts to change. »» [SEARCH] (search) is displayed.
6 Other features Set the alarm timer This micro system can be used as an alarm clock. You can select the disc or tuner as alarm source. •• Make sure that you have set the clock correctly. 2 3 4 5 6 7 8 This micro system can switch to standby mode automatically after a set period of time. When the system is turned on, press SLEEP repeatedly to select a preset period (in minutes). »» When the sleep timer is activated, is displayed.
7 Product information Dimensions (W x H x D) 134 x 230 x 152 mm General information Note •• Product information is subject to change without prior notice.
Clean the disc lens • After prolonged use, dirt or dust may accumulate at the disc lens. To ensure good play quality, clean the disc lens with Philips CD lens cleaner or any commercially available cleaner. Follow the instructions supplied with cleaner. Clean the heads and the tape paths • To ensure good play quality, clean the heads A, the capstan(s) B, and pressure roller(s) C after every 50 hours of tape operation. • Use a cotton swab slightly moistened with cleaning fluid or alcohol.
8 Troubleshooting Warning •• Never remove the casing of this product. To keep the warranty valid, never try to repair the product yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact the Consumer Care, make sure that the product is nearby and the model number and serial number are available.
9 Notice Any changes or modifications made to this device that are not expressly approved by WOOX Innovations may void the user’s authority to operate the equipment. Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health.
This equipment should not be used for such purposes. 2013 © WOOX Innovations Limited. All rights reserved. Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Limited under license from Koninklijke Philips N.V.” Specifications are subject to change without notice. WOOX reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly.
Specifications are subject to change without notice This product was brought to the market by WOOX Innovations Limited or one of its affiliates, further referred to in this document as WOOX Innovations, and is the manufacturer of the product. WOOX Innovations is the warrantor in relation to the product with which this booklet was packaged. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. MC151_05_UM_V1.
