User manual

8 EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Connect speakers
Note
• Insert the stripped portion of each speaker wire into
the socket completely.
• Forbettersoundquality,usethesuppliedspeakersonly.
• Connect only speakers with impedance that is the
same or higher than the supplied speakers (refer to the
"Specications"sectionofthismanual).
1 Fortherightspeaker,ndthesocketson
the the main unit marked "RIGHT".
2 Insert the red wire into the red (+) socket,
the black wire into the black (-) socket.
3 Fortheleftspeaker,ndthesocketsonthe
main unit marked "LEFT".
4 Repeat step 2 to insert the left speaker
wire.
To insert each speaker wire:
1 Holddownthesocketap.
2 Insert the speaker wire fully.
3 Releasethesocketap.
Connect power
Caution
• Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back of the micro system.
• Before connecting the AC power cord, make sure that
you have completed all other connections.
Connect the AC power cord to the power
outlet.
Prepare the remote control
Caution
• Risk of explosion! Keep batteries away from heat,
sunshineorre.Neverdiscardbatteriesinre.
To install the remote control battery:
1 Open the battery compartment.
2 Insert 2 AAA batteries (not supplied) with
correct polarity (+/-) as indicated.