Always there to help you Register your product and get support at www.philips.
Contents 1 Important Safety 9 Notice 2 2 2 Your Micro Hi-Fi System 4 4 4 5 6 3 Get started 8 8 8 8 9 9 Introduction What's in the box Overview of the main unit Overview of the remote control Connect speakers Connect power Prepare the remote control Set clock Turn on 4 Play 10 10 11 11 11 5 Listen to radio 12 12 12 12 12 6 Other features 13 13 13 13 7 Product information Specifications Maintenance 14 14 14 8 Troubleshooting 16 Play a disc Play a tape Play from an external device Adjust volu
1 Important • • Safety This 'bolt of lightning' indicates uninsulated material within the device may cause an electrical shock. For the safety of everyone in your household, please do not remove the covering. The 'exclamation mark' calls attention to features for which you should read the enclosed literature closely to prevent operating and maintenance problems.
• Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Warning •• Never remove the casing of this apparatus. •• Never lubricate any part of this apparatus. •• Never place this apparatus on other electrical equipment. •• Keep this apparatus away from direct sunlight, naked flames or heat. •• Never look into the laser beam inside the apparatus.
2 Your Micro Hi-Fi System Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.Philips.com/welcome.
Overview of the main unit a b c h d i e f j k l m g EN 5
a PULL TO OPEN • Open or close the disc compartment. b STANDBY-ON • Turn on the micro system. • Switch the system to standby mode. c iR • Receive infrared signals from the remote control. d SOURCE • Select a source: disc, tuner, tape or AUX (external audio source). e PRESET +/• Select a preset radio station. m PULL TO OPEN • Open the tape button cover. Overview of the remote control g a b c h i d j f DBB • Turn dynamic bass enhancement on or off. g Tape deck operation • Start tape play.
e PROG • Program tracks. • Program radio stations. f PRESET +/• Select a preset radio station. g POWER • Turn on the micro system. • Switch the micro system to standby mode. h SLEEP • Set the sleep timer. i CLOCK/DISPLAY • Set the clock. • Display play information. j TIMER • Set the alarm timer. k • Start or pause play. / • Search within a track or disc. • Tune to a radio station. / • Skip to the previous or next track. l DBB • Turn dynamic bass enhancement on or off. m • Stop play or erase a program.
3 Get started Always follow the instructions in this chapter in sequence. Connect speakers 1 2 3 Hold down the socket flap. Insert the speaker wire fully. Release the socket flap. Connect power Caution •• Risk of product damage! Make sure that the power supply voltage corresponds to the voltage printed on the back of the micro system. •• Before connecting the AC power cord, make sure that you have completed all other connections. Connect the AC power cord to the power outlet.
Turn on Press POWER. »» The micro system switches to the last selected source. Switch to standby mode Note •• Batteries contain chemical substances, so they should be disposed of properly. »» The clock (if set) appears on the display panel. Set clock 1 2 3 4 5 6 7 8 Press POWER to switch the system to standby mode. »» The backlight on the display panel is dimmed. Press POWER to switch the system to standby mode. »» --:-- (or clock) is displayed.
4 Play Play a disc Start or pause play. Stop play. Repeat play 1 Note •• Make sure that the disc contains playable audio content. 1 On the top panel, pull up to open the disc compartment. 2 Insert a disc with the printed side facing up, then close the disc compartment. 2 During play, select a repeat play mode: • To play the current track repeatedly, press REPEAT on the main unit. • To play all tracks repeatedly, press REP ALL on the remote control.
Display play information During play, press CLOCK/DISPLAY repeatedly to view different play information. Play from an external device With this micro system, you can also play audio from an external device such as an MP3 player. 1 Play a tape Connect an audio cable (not supplied) with 3.5 mm plug on both ends between: • the AUX socket on the micro system, and • the headphone socket on an external device. PULL TO OPEN AUX 1 2 3 4 5 Press TAPE to select the tape source.
5 Listen to radio Program radio stations manually Note Tune to an FM/AM radio station Tip •• For better reception, fully extend and adjust the position of the antenna. 1 2 3 Press TUN to select radio source. Press and hold / until the frequency starts to change. »» [SEARCH] (search) is displayed. stations. •• To overwrite a programmed radio station, store another station in its place. 1 2 3 Tune to a radio station. Press PROG to activate programming. »» [PROG] blinks on the display.
6 Other features Note •• The alarm timer is not available in AUX mode. •• If the selected alarm source is unavailable, tuner is activated automatically. Set the alarm timer This micro system can be used as an alarm clock. You can select the disc or tuner as alarm source. Note •• Make sure that you have set the clock correctly. 1 2 3 4 5 6 7 8 Press POWER to switch the system to standby mode. »» The clock is displayed. Press and hold TIMER for 2 seconds until a prompt to select the source is displayed.
7 Product information Speakers Speaker Impedance Dimensions (W x H x D) 8 ohm 134 x 230 x 152 mm Note •• Product information is subject to change without prior notice.
CD lens cleaner or any commercially available cleaner. Follow the instructions supplied with cleaner. Clean the heads and the tape paths • TTo ensure good play quality, clean the heads A, the capstan(s) B, and pressure roller(s) C after every 50 hours of tape operation. • Use a cotton swab slightly moistened with cleaning fluid or alcohol. • You can also clean the heads by playing a cleaning tape once. Demagnetise the heads • Use a demagnetising tape available at your dealer.
8 Troubleshooting Warning •• Never remove the casing of this product. To keep the warranty valid, never try to repair the product yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact the Consumer Care, make sure that the product is nearby and the model number and serial number are available.
9 Notice Any changes or modifications made to this device that are not expressly approved by WOOX Innovations may void the user’s authority to operate the equipment. Compliance This product complies with the radio interference requirements of the European Community. This apparatus includes this label: Care of the environment Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
Specifications are subject to change without notice. 2014 © WOOX Innovations Limited. All rights reserved. Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Limited under license from Koninklijke Philips N.V. MC151_12_UM_V2.
