operation manual

10 EN
1 Connect the power cord to the
AC~MAINS jack on the main unit.
2 Connect the power plug to the wall
outlet.
Install remote control
batteries
Caution
Risk of explosion! Keep batteries away from heat, •
sunshine or fi re. Never discard batteries in fi re.
Risk of decreased battery life! Never mix different •
brands or types of batteries.
Risk of product damage! When the remote control is •
not used for long periods, remove the batteries.
1 Open the battery compartment.
2 Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
AC MAINS ~
3
1
2
Set clock
1 In standby mode, press and hold
CLOCK/DISPLAY to activate the clock
setting mode.
[SET CLOCK] (set clock) is displayed »
briefl y. Then the hour digits are
displayed and begin to blink.
Note
In Eco Power Standby mode, press • CLOCK to show
clock fi rst, then press and hold CLOCK to proceed
clock setting.
2 Press repeatedly to select 12 hour or
24 hour format.
3 Press VOL +/- to set the hour.
4 Press CLOCK/DISPLAY to confi rm.
The minute digits are displayed and »
begin to blink.
5 Press VOL +/- to set the minute.
6 Press CLOCK/DISPLAY to confi rm.
Turn on
1 Press POWER on the main unit.
The unit switches to the last selected »
source.
Switch to standby
1 Press POWER to switch the unit to
standby mode.
The backlight on the display panel »
turns off.
The clock (if set) appears on the »
display panel.
Note
If no button is pressed over 15 minutes in Standby •
mode, the unit goes to Eco Power Standby mode
automatically and the backlight on the display turns off.