User manual

BC
NT1605, NT1715NT1605, NT171
5
>75 % recycled paper
>75 % papier recyclé
Specications are subject to change without
notice.
© 2022 Koninklijke Philips N.V.
All rights reserved.
Las especicaciones están sujetas a
modicaciones sin previo aviso.
© 2022 Koninklijke Philips N.V.
Todos los derechos reservados.
4222.002.9248.3 (06/09/2022)
English
IMPORTANT SAFETY
INSTRUCTIONS
When using an electric product, basic
precautions should always be followed,
including the following:
Read all instructions before using this
product.
WARNING
To reduce the risk of burns, re, electric
shock, or injury to persons:
- Use product only in dry condition. Do not
use while bathing or in a shower.
- This product is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the product
by a person responsible for their safety.
Children should be supervised to ensure
that they do not play with the product.
- Use this product only for its intended
household use as described in this manual.
Misuse can lead to hazards or serious
injuries. Do not use attachments not
recommended by Philips North America
LLC. Accessories supplied may vary for
dierent products.
- Never drop or insert any object into any
opening.
- Never operate this product if it is not
working properly, after it has been dropped
or damaged, or after the product has been
dropped into water. For assistance call
1-800-243-3050 (US) or [phone]
(Canada).
- Do not use this product outdoors or operate
where aerosol (spray) products are being
used or where oxygen is being administered.
- Always check cuttings units and other
attachments and accessories before you
use the product. Never use the product
with a damaged cutting unit, attachment
or accessory, as injury may occur.
- Only use the accessories supplied with the
product.
- Only use original Philips accessories or
consumables.
- Only operate this product on disposable
1.5V AA alkaline batteries.
- Do not recharge non-rechargeable batteries.
- Keep product and batteries away from re
and do not expose them to direct sunlight
or high temperatures.
- If the product becomes abnormally hot
or smelly, or changes color, stop using the
product and contact Philips.
- Do not place products and their batteries in
microwave ovens or on induction cookers.
- Do not modify, pierce, damage or dismantle
the product or battery to prevent batteries
from heating up or releasing toxic or
hazardous substances. Do not short-circuit,
overcharge or reverse charge batteries.
- If batteries are damaged or leaking, avoid
contact with the skin or eyes. If this occurs,
immediately rinse well with water and seek
medical care.
- When you handle batteries, make sure that
your hands, the product and the batteries
are dry.
- Insert batteries with the + and - poles
pointing in the direction indicated in the
battery compartment or holder.
- Do not mix dierent brands and types
of batteries, do not mix new and used
batteries and do not use batteries with
dierent date codes.
- Remove batteries from the product if you
are not going to use it for some time.
- To avoid accidental short-circuiting of
batteries after removal, do not let battery
terminals come into contact with metal
objects (e.g. coins, hairpins, rings). Do not
wrap batteries in aluminum foil. Tape
battery terminals or put batteries in a
plastic bag before you discard them.
- Do not leave empty disposable batteries
inside the product.
SAVE THESE INSTRUCTIONS
IMPORTANT INFORMATION
- Rinse the cutting element of the trimming
head with lukewarm water after each use
(Fig. 2).
- Be careful to always keep the cutting
element away from eyes and eyelashes.
- For hygienic reasons, the product should
only be used by one person.
- Apply gentle pressure. Pressing too hard
may cause skin irritation, and the trimmer
will not function properly.
- Do not use trimmer on sensitive areas or
irritated skin.
Introduction
Congratulations on your purchase and
welcome to Philips Norelco!
To fully benet from the support that Philips
Norelco oers, register your product at
www.norelco.com/register.
You can nd the model number printed inside
the battery compartment. You can access the
battery compartment by removing the lower
part of the handle.
The full model number (e.g. NT1234/56) is
located on the bottom of the packaging, your
receipt or order conrmation.
General Description (Fig.1)
1 Short eyebrow guard (1/8in./3mm)
2 Cutting element
3 Trimming head
4 ‘Unlocked‘ indication
5 Locking indicator
6 ‘Locked‘ indication
7 Handle
8 Setting indicator
9 ‘On‘ indication
10 ‘O’ indication
11 ‘Open’ indication
12 Battery compartment cover
13 AA battery
14 Cleaning brush
Preparing for use
Placing the battery
Note: Make sure your hands and product are
dry when inserting the battery.
1 To remove the battery compartment cover,
turn it clockwise (Fig. 3) until the setting
indicator points to the ‘unlocked‘ indication
(^) (Fig. 4).
2 Pull the battery compartment cover o the
handle (Fig. 5).
3 Put the battery in the battery compartment
(Fig. 6).
Make sure the + and - poles of the battery
point in the right direction.
Note: The product operates on one
disposable 1.5V AA alkaline battery
(included).
4 Slide the battery compartment cover back
onto the handle (Fig. 7).
5 Turn the battery compartment cover
counterclockwise until the setting indicator
points to the ‘o’ indication (0) (Fig. 8).
Using the product
Use the product for the following purposes:
- Trimming your nose and ear hair with the
cutting element of the trimming head.
- Trimming your eyebrows with the eyebrow
guard attached to the cutting element of
the trimming head.
AA
Max.
30
min
2
5
8
11
14
17
20
3
6
9
12
15
18
21
4
7
10
13
16
19
AA
1
2
3
7
8
9
12
10
11
13 14
6 5 4
3 mm
1/8 in.
1
Note: The nose trimmer is not designed to
clean-shave your nostrils or ear channels, but
to cut the hairs to a shorter length. Nose and
ear hairs have important protective functions
and should not be fully removed.
Switching the product on and o
1 To switch on the product, turn the battery
compartment cover counterclockwise until
the setting indicator aligns with the ‘on‘
indication (I) (Fig. 8).
2 To switch o the product, turn the battery
compartment cover clockwise until the
setting indicator aligns with the ‘o‘
indication (0) (Fig. 9).
Trimming eyebrows with the eyebrow
guard
1 Comb your eyebrows in the direction of
hair growth (Fig. 10).
2 Make sure the product is switched o.
Slide the eyebrow guard onto the cutting
element (Fig. 11). The short eyebrow guard
trims the hairs to a length of 1/8in./3mm.
Note: Make sure the guard clicks into place.
3 Switch on the product.
4 Place the trimmer in a position
perpendicular to your face. Make sure that
the back of the guard lies at on the skin
(Fig. 12).
5 Slowly move the trimmer against the hair
growth direction (Fig. 13). Press lightly and
make sure that the at surface of the guard
always stays in contact with the skin.
6 Clean thoroughly after each use (see
‘Cleaning‘).
Trimming nose hair
Make sure both the product and nasal
passages are clean before trimming. Dried
nasal mucus can block the cutting element,
preventing the product from turning on.
Note: If there is an eyebrow guard attached
to the cutting element, remove it before
trimming nose or ear hair. (Fig. 14)
1 Switch on the product.
2 Carefully insert the cutting element into
one of your nostrils.
Be careful not to insert the cutting
element too deep into the nostrils
(max.15/32in./12 mm).
3 Move the cutting element in and out of
the nostril in a rm, rotary motion to cut
the hairs to a shorter length (Fig. 15). Make
sure that the cutting teeth touch the hair
by rotating the cutting element inside your
nostril. While rotating you may hold the
at side of the trimmer against the skin to
reduce any tickling eect that might occur.
4 Clean thoroughly after each use (see
‘Cleaning‘).
Trimming ear hair
Make sure your outer ear channels are clean
and free from wax.
Note: If there is an eyebrow guard attached
to the cutting element, remove it before
trimming nose or ear hair. (Fig. 14)
1 Switch on the product.
2 Slowly move the cutting element along the
rim of the ear to remove hairs that stick out
beyond the rim.
3 Carefully insert the cutting element into the
outer ear channel. Move the tip in and out
of the outer ear channel in a rm, rotary
motion to cut the hairs to a shorter length
(Fig. 16).
Do not insert the cutting element too deep
into your ear channel, as this could damage
the eardrum (max. 15/32 in./12 mm).
4 Clean thoroughly after each use (see
‘Cleaning‘).
Cleaning
Clean the product immediately after use and
when a lot of hair or dirt has accumulated on
the cutting element.
Do not immerse the motor unit in water or
any other liquid, or rinse it under the tap.
Only the trimming head and attachments
can be rinsed under the tap.
Never use scouring pads, abrasive cleaning
agents or aggressive liquids such as
gasoline or acetone to clean the product.
Do not tap on the cutting elements.
Do not use any sharp objects to clean the
cutting elements.
Never dry the cutting unit with a towel or
tissue, as this may damage the trimming
teeth.
1 Use the cleaning brush to remove any
excess hair from the cutting element
(Fig.17).
2 Rinse the cutting element of the trimming
head with lukewarm tap water (Fig. 18).
3 Switch on the product and rinse the
cutting element once more to remove any
remaining hairs (Fig. 18). Then switch o
the product again.
Tip: For a thorough clean, immerse the
trimming head in a glass with warm water
for ca. 30 minutes to soak and soften the
debris. Be careful not to immerse the handle
in water. Then switch on the product and rinse
the cutting element under the tap to remove
stubborn hair/debris.
4 Rinse the eyebrow guard with lukewarm
water (Fig. 20).
You can also use the cleaning brush to
clean the eyebrow guard.
5 Carefully shake o excess water and let
all parts air-dry (Fig. 21). Let all parts dry
completely before you use the product
again.
Storage
Store the product in a safe, dry location.
Attach the eyebrow guard to the cutting
element to protect the cutting teeth during
storage.
Assistance
For assistance, visit our website:
www.philips.com/support or call toll free
1-800-243-3050.
Online information is available 24 hours a day,
7 days a week.
Disposal
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused. For
recycling information, please contact your
local waste management facilities or visit
www.recycle.philips.com.
This product contains batteries:
- Dispose of batteries properly. Do not
incinerate. Batteries may explode if
overheated.
- Do not wrap in metal or aluminum foil.
Tape the waste battery terminals before
discarding.
- It is suggested that you contact your local
town or city to determine proper battery
redemption site(s) in your area.
Removing the disposable battery
To remove the disposable battery, see chapter
‘Preparing for use‘.
45-DAY MONEY-BACK GUARANTEE
If you are not fully satised with your product
send the product back and we’ll refund you
the full purchase price.
The product must be shipped prepaid
by insured mail, insurance prepaid, have
the original sales receipt, indicating
purchase price and date of purchase,
and the money-back guarantee return
authorization form enclosed.
We cannot be responsible for lost mail.
The product must be postmarked no later
than 45 days after the date of purchase.
Philips reserves the right to verify the
purchase price of the product and limit
refunds not to exceed suggested retail price.
NT1605-NT1715-US_4222.002.9248.3_LFLT_FoldedA7_BW.indd 1-4NT1605-NT1715-US_4222.002.9248.3_LFLT_FoldedA7_BW.indd 1-4 21-07-22 11:1221-07-22 11:12