User manual

NT5600
N
T5
600
>75 % recycled paper
>75 % papier recyclé
Specications are subject to change without
notice.
© 2023 Koninklijke Philips N.V.
All rights reserved.
Las especicaciones están sujetas a
modicaciones sin previo aviso.
© 2023 Koninklijke Philips N.V.
Todos los derechos reservados.
3000.110.2639.2 (22/05/2023)
English
IMPORTANT
SAFETY
INSTRUCTIONS
When using an electric product, basic
precautions should always be followed,
including the following:
Read all instructions before using this
product.
WARNING
To reduce the risk of burns, re, electric
shock, or injury to persons:
- Use product only in dry condition. Do not
use while bathing or in a shower.
- This product is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the product
by a person responsible for their safety.
Children should be supervised to ensure
that they do not play with the product.
- Use this product only for its intended
household use as described in this manual.
Misuse can lead to hazards or serious
injuries. Do not use attachments not
recommended by Philips North America
LLC. Accessories supplied may vary for
dierent products.
- Never drop or insert any object into any
opening.
- Never operate this product if it is not
working properly, after it has been dropped
or damaged, or after the product has been
dropped into water. For assistance call
1-800-243-3050.
- Do not use this product outdoors or operate
where aerosol (spray) products are being
used or where oxygen is being administered.
- Always check cutting units and other
attachments and accessories before you
use the product. Never use the product
with a damaged cutting unit, attachment
or accessory, as injury may occur.
- Only use the accessories supplied with the
product.
- Only use original Philips accessories or
consumables.
- Only operate this product on disposable
1.5V AA alkaline batteries.
- Do not recharge non-rechargeable batteries.
- Keep product and batteries away from re
and do not expose them to direct sunlight
or high temperatures.
- If the product becomes abnormally hot
or smelly, or changes color, stop using the
product and contact Philips.
- Do not place products and their batteries in
microwave ovens or on induction cookers.
- Do not modify, pierce, damage or dismantle
the product or battery to prevent batteries
from heating up or releasing toxic or
hazardous substances. Do not short-circuit,
overcharge or reverse charge batteries.
- If batteries are damaged or leaking, avoid
contact with the skin or eyes. If this occurs,
immediately rinse well with water and seek
medical care.
- When you handle batteries, make sure that
your hands, the product and the batteries
are dry.
- Insert batteries with the + and - poles
pointing in the direction indicated in the
battery compartment or holder.
- Do not mix dierent brands and types
of batteries, do not mix new and used
batteries and do not use batteries with
dierent date codes.
- Remove batteries from the product if you
are not going to use it for some time.
- To avoid accidental short-circuiting of
batteries after removal, do not let battery
terminals come into contact with metal
objects (e.g. coins, hairpins, rings). Do not
wrap batteries in aluminum foil. Tape
battery terminals or put batteries in a
plastic bag before you discard them.
- Do not leave empty disposable batteries
inside the product.
SAVE THESE
INSTRUCTIONS
IMPORTANT INFORMATION
- Rinse the cutting element of the trimming
head with lukewarm water after each use
(Fig. 2).
- Be careful to always keep the cutting
element away from eyes and eyelashes.
- For hygienic reasons, the product should
only be used by one person.
- Apply gentle pressure. Pressing too hard
may cause skin irritation, and the trimmer
will not function properly.
- Do not use trimmer on sensitive areas or
irritated skin.
General description (Fig. 1)
1 Short eyebrow guard 1/8in. (3mm)
2 Long eyebrow guard 13/64in. (5mm)
3 Protection cap
4 Cutting element
5 Trimming head
6 'Unlocked' indication
7 'Locked' indication
8 Setting indicator
9 Handle
10 On/o slide
11 Detail trimmer
12 Rotary trimmer
13 AA battery
14 Cleaning brush
Not shown: pouch
Introduction
Congratulations on your purchase and
welcome to Philips Norelco!
To fully benet from the support that Philips
Norelco oers, register your product at
www.norelco.com/register.
You can nd the model number printed inside
the battery compartment. You can access the
battery compartment by removing the lower
part of the handle.
The full model number (e.g. NT1234/56) is
located on the bottom of the packaging, your
receipt or order conrmation.
Preparing for use
Inserting the battery
1 To remove the battery compartment cover,
turn it clockwise (Fig. 3) until the setting
indicator points to the 'unlocked' indication
(^) (Fig. 4).
2 Pull the battery compartment cover o the
handle (Fig. 5).
3 Put the battery in the battery compartment.
Make sure the + and - poles of the battery
point in the right direction.
Note: The product operates on one
disposable 1.5V AA alkaline battery
(included).
4 Slide the battery compartment cover back
onto the handle (Fig. 6).
5 Turn the battery compartment cover
counterclockwise until the setting indicator
points to the 'locked' indication (0) (Fig. 7).
Using the product
Switching the product on and o
1 To switch on the product, slide the on/o
slide upwards (Fig. 8).
2 To switch o the product, slide the on/o
slide downwards (Fig. 9).
Detaching and attaching the attachments
Note: Switch o the product before
attempting to detach or attach the
attachments.
3 To detach an attachment from the handle,
rmly grip the attachment below the
cutting element and turn it until the setting
indicator points to the 'unlocked' indication
(^). Then lift the attachment o of the
handle (Fig. 10).
4 To attach an attachment, place the
attachment on the handle with the setting
indicator pointing to the 'unlocked'
indication (^). Firmly grip the attachment
below the cutting element and turn it until
the setting indicator points to the 'locked'
indication (0) (Fig. 11).
Trimming eyebrows with the eyebrow
guard
1 Comb your eyebrows in the direction of
hair growth (Fig. 12).
2 Make sure the product is switched o. Slide
the eyebrow guard onto the trimming head
(Fig. 13). The short eyebrow guard trims the
hairs to a length of 1/8in. (3mm). The long
eyebrow guard trims the hairs to a length
of 13/64in. (5mm).
AA
3
5
9
10
4
12 13 1411
8 67
1/8 in.
(3 mm
)
13/64 in.
(5 mm)
1 2
Max.
30
min
2
1
14
8
20
5
17
11
23
26
3
15
9
21
6
18
12
24
27
4
16
10
22
7
19
31
15
Note: Make sure the guard clicks into place.
3 Switch on the product (Fig. 8).
4 Place the trimmer in a position
perpendicular to your face. Make sure that
the back of the guard lies at on the skin
(Fig. 14).
5 Slowly move the trimmer against the hair
growth direction (Fig. 15). Press lightly
and make sure that the surface of the
guard always stays in contact with the skin.
Repeat until all the hairs that should be cut
have been cut.
6 Clean thoroughly after each use (see
'Cleaning').
Trimming ear hair
Make sure your outer ear channels are clean
and free from wax.
Note: If there is an eyebrow guard attached
to the cutting element, remove it before
trimming nose or ear hair. (Fig. 16)
1 Switch on the product (Fig. 8).
2 Slowly move the trimming head along the
rim of the ear to remove hairs that stick out
beyond the rim.
3 Carefully insert the trimming head into the
outer ear channel.
Do not insert the cutting element too deep
into your ear channel, as this could damage
the eardrum (max. 15/32 in./12 mm).
4 Move the tip in and out of the outer ear
channel in a rm, rotary motion to cut the
hairs to a shorter length (Fig. 17).
5 Clean thoroughly after each use (see
'Cleaning').
Tip: You can also trim hairs in the outer ear
channel using the rotary trimmer (see 'Using
the rotary trimmer').
Using the rotary trimmer
The rotary trimmer attachment can also be
used to trim hairs in the nostrils or ears.
1 Attach the rotary trimmer to the product
(see 'Detaching and attaching the
attachments').
2 Gently insert the rotary trimmer into your
nostril or outer ear channel.
Do not insert the trimming head too deep
into your nostrils or ear channels (max.
3/16 in. / 5 mm).
3 When trimming both nose and ear hair,
make rm, rotary movements to ensure
that the trimming head reaches all the
hairs.
4 Clean the attachment thoroughly after
each use.
Cleaning
Make sure that the battery compartment is
properly closed before rinsing the product
under the tap.
Never use scouring pads, abrasive cleaning
agents or aggressive liquids such as
gasoline or acetone to clean the product or
any attachments or accessories.
Do not tap on the cutting elements.
Do not use any sharp objects to clean the
cutting elements.
Clean the trimming head and eyebrow guards
immediately after use and when a lot of
hair or dirt has accumulated on the cutting
elements.
1 Use the cleaning brush to remove any
excess hair from the cutting element
(Fig. 20).
2 Rinse the cutting element with lukewarm
water under the tap.
3 Switch on the product and rinse the
cutting element again (Fig. 21) to remove
any remaining hairs. Then switch o the
product again.
4 If the rotary trimmer is attached, detach it
from the handle. Turn the rotary trimmer
upside down and rinse it with lukewarm
water (Fig. 22).
Tip: For a thorough clean, immerse the
trimming head in a glass with warm water
for ca. 30 minutes to soak and soften the
debris (Fig. 23). Be careful not to immerse
the handle in water. Then switch on the
product and rinse the cutting element under
the tap to remove stubborn hair/debris.
5 Rinse the eyebrow guards with lukewarm
water (Fig. 24). You can also use the
cleaning brush to clean the eyebrow
guards.
6 Carefully shake o excess water and let all
parts air-dry (Fig. 27).
Cleaning the detailer
Clean the detail trimmer immediately after use
and when a lot of hair or dirt has accumulated
on the cutting element.
1 Use the brush to remove any excess hair
from the detail trimmer (Fig. 25).
2 Switch on the product and rinse the detail
trimmer with lukewarm tap water (Fig. 26).
3 Switch o the product again.
4 Carefully shake o excess water and let all
parts air-dry (Fig. 27).
Let all parts dry completely before you use the
product again.
Storage
Store the product in a safe, dry location,
using the protection cap and pouch provided.
Ensure that the product and accessories are
completely dry before sliding the protection
cap into place and inserting them into the
pouch.
Assistance
For assistance, visit our website:
www.philips.com/support or
call toll free 1-800-243-3050.
Disposal
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused. For
recycling information, please contact your
local waste management facilities or visit
www.recycle.philips.com.
This product contains batteries:
- Dispose of batteries properly. Do not
incinerate. Batteries may explode if
overheated.
- Do not wrap in metal or aluminum foil.
Tape the waste battery terminals before
discarding.
- It is suggested that you contact your local
town or city to determine proper battery
redemption site(s) in your area.
Removing the disposable battery
To remove the disposable battery, see chapter
'Preparing for use'.
45-DAY MONEY-BACK GUARANTEE
If you are not fully satised with your product
send the product back and we’ll refund you
the full purchase price.
The product must be shipped prepaid by
insured mail, insurance prepaid, have the
original sales receipt, indicating purchase
price and date of purchase, and the money-
back guarantee return authorization form
enclosed.
We cannot be responsible for lost mail.
The product must be postmarked no later
than 45 days after the date of purchase.
Philips reserves the right to verify the
purchase price of the product and limit
refunds not to exceed suggested retail
price.
To obtain the money-back guarantee
service, please go to www.
PhilipsMoneyBack.com and follow the
simple 3-step process.
Delivery of refund check will occur 6–8 weeks
after receipt of returned product.
Full Two-Year Warranty
Philips North America LLC warrants this new
product (except cutters and combs) against
defects in materials or workmanship for a
period of two years from the date of purchase,
and agrees to repair or replace any defective
product without charge.
3000.110.2639.2_NT5600_IID-US-WASHABLE_folded_A7_BW.indd 1-6
3000.110.2639.2_NT5600_IID-US-WASHABLE_folded_A7_BW.indd 1-6
22-05-2023 14:42
22-05-2023 14:42