Remote Control User Manual
Table Of Contents
- Onis 6311
- Onis 6511
- The display
- Table of contents
- Safety information
- Installing your Onis
- Using your Onis
- The caller list
- Your Onis Memo recorder
- Personalising your telephone
- Your Phone book and emergency number
- Using advenced functions
- Connection to a PABX
- Useful tips and maintenance
Your Onis Memo recorder 17
Note:
You can correct an error when you are entering your remote control code (RCC)
by using the
+
key.
If you wish to change your remote control code, repeat the above procedu re.
If you to wish to erase the remote control code during step of the procedure
described above, press
+
four times, then press
o
, and finally press
R
.
Changing the number of rings
You can change the number of times your telephone rings before your memo
recorder answers a call.
Press
R
, then press
-
until you reach
$16: 6(783
.Press
o
.
Press
-
until you reach RINGS, then press
o
.
Press
-
or
+
to select 2 RINGS, 3 RINGS, 4 RINGS, 5 RINGS, or TOLL
SAVER, then press
o
to confirm your choice.
Press
R
to exit menu mode.
The Save function
72// 6$9(5
This is used when you call into your memo recorder by remote control (see
Calling
into your memo recorder by remote control
on page 19).
When
72// 6$9(5
is selected, you can tell if a new message has been received
since you last rang in.
If your memo recorder has received messages, it will answer on the
third
ring.
If no messages have been recorded, it will answer on the
fifth
ring.
3
1
2
3
4
Tip
If there are no messages, you can hang up after the
fourth
ring
and not pay for the call.