Remote Control User Manual
Table Of Contents
- Onis 6311
- Onis 6511
- The display
- Table of contents
- Safety information
- Installing your Onis
- Using your Onis
- The caller list
- Your Onis Memo recorder
- Personalising your telephone
- Your Phone book and emergency number
- Using advenced functions
- Connection to a PABX
- Useful tips and maintenance
Useful tips and maintenance 31
Memo recorder troubleshooting (Oniso Memo only)
If further troubleshooting is necessary, please contact your PHILIPS Help
Desk.
Problem Cause Solution
The memo recorder does not
record your outgoing message.
You are not close enough to the
handset microphone.
Record a new outgoing message
closer to the microphone.
The memory is full. Erase messages to free sufficient
memory capacity.
The memo recorder does not
record the incoming calls.
You have not switched on the memo
recorder.
See
Switching on the memo
recorder
on page 13.
The message record switch is set to
off.
See
Switching message record
on or off
on page 18.
The memo recorder stopped
automatically.
The memo recorder memory is full. Erase messages to free sufficient
memory capacity.
The red indicator light on the
base station flashes quickly.
The memo recorders maximum
recording capacity has been
reached.
Erase messages to free sufficient
memory capacity.
A power failure has occurred. Reset the day and time setting of
the handset (see
Setting the day
and time
on page 13).
12 287 0(6
is displayed. You have not recorded an outgoing
message.
See
Recording an outgoing
message
on page 12.
The remote control does not
work.
You have not entered the right code. Try again or see
Calling into your
memo recorder by remote control
on page 19.
You have not set a remote control
code.
See
Entering a remote control
code
on page 16.
The answering machinesmaximum
recording capacity has been
reached.
Erase messages to free sufficient
memory capacity.