User manual

20 EN
Important notes for users in
the U.K.
Mains fuse
This information applies only to products with a
UK mains plug.
Thisproductisttedwithanapprovedmolded
plug. If you replace the fuse, use one with:
• the ratings shown on the plug,
• a BS 1362 approval, and
• the ASTA approval mark.
Contact your dealer if you are not sure about
what type of fuse to use.
Caution: To conform with the EMC directive
(2004/108/EC),donotdetachtheplugfrom
the power cord.
How to connect a plug
The wires in the power cord are colored as
follows:blue=neutral(N),brown=live(L).
If the colors do not correspond with the colors
on your plug, identify the terminals in your plug
as follows:
1 Connect the blue wire to the terminal
marked N or colored black.
2 Connect the brown wire to the terminal
marked L or colored red.
3 Do not connect either wire to the earth
terminalintheplug,markedE(ore)or
coloredgreen(orgreenandyellow).
Before you replace the plug cover, make sure
that the cord grip is clamped over the sheath of
the cable and not just over the two wires in the
cable.
Copyright in the U.K.
Recording and playback of material may require
consent. see Copyright Act 1956 and The
performer’s Protection Acts 1958 to 1972.
Trademark notice
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by WOOX
Innovations is under license.
Copyright
2014 © WOOX Innovations Limited. All rights
reserved.
Specicationsaresubjecttochangewithout
notice. WOOX reserves the right to change
products at any time without being obliged to
adjust earlier supplies accordingly.