User Guide

19
www.philips.com/support
If you have any problems, visit www.philips.com/support for a list of frequently asked questions or contact the
Consumer Care Center in your country.
Problem Cause Solution
The ironing board cover
becomes wet or there are water
droplets on the garment during
ironing.
Steam has condensed on the ironing
board cover after a long ironing session.
Replace the ironing board cover if the foam material has worn out.
You can also add an extra layer of felt material under the ironing
board cover to prevent condensation on the ironing board. You
can buy felt in a fabric shop.
You have an ironing board cover that
is not designed to cope with the high
steam rate of the appliance.
Put an extra layer of felt material under the ironing board cover to
prevent condensation on the ironing board. You can buy felt in a
fabric shop.
Water droplets come out of the
soleplate.
The steam that was still present in the
hose has cooled down and condensed
into water. This causes water droplets to
come out of the soleplate.
Steam away from the garment for a few seconds.
Steam and/or water come out
from under the EASY DE-CALC
knob.
The EASY DE-CALC knob is not tightened
properly.
Switch o the appliance and let the appliance cool down for 2
hours. Unscrew the EASY DE-CALC knob and screw it back onto
the appliance properly. Note: Some water may escape when you
remove the knob.
The rubber sealing ring of the EASY DE-
CALC knob is worn.
Contact an authorised Philips service centre for a new EASY DE-
CALC knob.
Dirty water and impurities
come out of the soleplate or the
soleplate is dirty.
Impurities or chemicals present in the
water have deposited in the steam vents
and/or on the soleplate.
Clean the soleplate with a damp cloth.
Too much scale and minerals have
accumulated inside the appliance.
Descale the appliance regularly (see chapter ‘Descaling appliance’).
Trouble shooting
故障排除