operation manual

1 Hold the shaver upside down above the holder with the back of the
shaver pointing towards the holder.
2 Place the shaver body in the holder behind the two clips (1)
and press it down until it locks into place (2).
, The display shows that the shaver is charging (see chapter
‘The display’).
3 Press the on/off button on the Jet Clean System to start the cleaning
program.
, The shaver display stops showing the charging indication.
, Thecleaninglightstartstoashandtheshaverisautomatically
loweredintothecleaninguid.
, Thecleaninglightashesthroughoutthecleaningprogram,
which takes a few minutes.
, Duringtherstphaseofthecleaningprogram,theshaverautomatically
switches on and off several times and moves up and down.
, During the second phase of the cleaning program, the shaver is
placedinthedryingposition,indicatedbytheashingdryingsymbol.
This phase takes approx. 2 hours. The shaver stays in this position
until the end of the program.
, After the cleaning program, the charging indication appears on the
shaver display (see chapter ‘The display’).
Note: If you press the on/off button of the Jet Clean System during the cleaning
program, the program aborts. In this case, the cleaning or drying light stops
ashing and the holder moves to the highest position.
Note: If you remove the adapter from the wall socket during the cleaning program,
the program aborts. The holder remains in its current position. When you put
the adapter back into the wall socket, the holder moves to the highest position.
ENGLISH 17