Operation Manual

RU240- page 3

Try it out! The easiest way to find out how your new remote works, is to

try pressing the keys and see what happens - don't worry, you won't

damage anything! Most of the keys work just like on your original remote

control. Of course, if your TV does not offer a specific function, pressing

that key will have no effect.

DON'T FORGET THE BATTERIES!

You'll need two 1.5V batteries, type R03,

UM4 or AAA only. Put them in like this.

Remember to replace the batteries at least

once a year. Don't leave the batteries out

for longer than one hour, otherwise you

will need to set the remote up again.

GETTING STARTED

This remote is ready to work with any Philips TV. For other brands of

equipment, it needs to be set up first. That only takes a couple of

seconds, thanks to Philips' Simple System Setup!

Before you start, make sure the equipment is switched on. Sit right in

front of it.

If you know the brand of your equipment, look at the code list at the

back of this booklet, and find the first 3-digit code for your equipment.

1 Press and hold and at the same time until the green LED

lights up. (Release the keys, the green LED should stay on)

2 Enter the 3-digit code using the keypad. The green LED blinks twice.

That's it! Now, press a few keys on the remote to check that the

equipment responds correctly. If it doesn't, try again using the next code

in the list. In the rare instance that none of the codes work, follow the

instructions in the next section.

Tip: Make a note of the code inside the battery case, and in the back of

this booklet in case you ever need to setup again.

If you don't know the brand of your equipment or if you can not find

it in the codelist, setup still won't take long. Philips' patented Handsfree

autosearch tests all the codes one after another and finds the right one

for you! The search time averages about 90 seconds. (Maximum search

time is 5 minutes for TV)

Make sure the TV is switched on. You will know when the correct code

has been found because the equipment will switch off.

1 Press and hold and at the same time until the green LED

lights up.

2 Press to start the search. Each time the green LED blinks, another

code is sent. When the right code is found, the equipment switches

off.

English