User manual

Protection against electric shock Class II
Protections rating IP 30 (EN 60529)
Operating conditions Temperature:+15 ºC to 35°C
 Relative humidity: 30% to 95%
Spectrum of body attachment >530nm
Spectrum ofprecision attachment >600nm
Troubleshooting
This chapter summarizes the most common problems you could encounter
with the device. If you are unable to solve the problem with the information
below, visit www.philips.com/support for a list of frequently asked questions
or contact the Consumer Care Center in your country.
Problem Possible cause Solution
The device/adapter
becomes warm during use
This is normal. No action required.
When I place the device on
the skin it does not release
a flash. The ' ready to flash
light blinks orange and
then lights up orange
continuously.
You skin tone in the area to
be treated is too dark.
Treat other body areas with lighter skin
tones with Lumea.
The 'ready to flash light'
doesn't light up when I
place the attachment on
my skin, but the cooling fan
works.
The overheat protection has
been activated.
When the overheat protection has been
activated, the fan still works. Do not
switch off the device, but let it cool down
for approx.15 minutes before you
continue to use it.
The 'ready to flash light'
lights up white but the
device does not produce a
flash when I press the flash
button.
The device needs to be reset. To reset the device, switch it off and
switch it on again.
I cannot increase or
decrease the light intensity
settings/All intensity lights
are blinking alternately
The device needs to be reset. To reset the device, switch it off and
switch it on again.
The attachment or the filter
glass is dirty.
Clean the attachment carefully.The device produces a
strange smell.
You have not removed the
hairs on the area to be
treated properly. These hairs
may get burned and can
cause the smell.
Pretreat your skin before you use Lumea.
17
English