User manual

Technical specifications
Rated voltage 100V-240V
Rated frequency 50Hz-60Hz
Rated input 7,5W
Protection against electric shock Class II
Protections rating IP 30 (EN 60529)
Operating conditions Temperature:+15 ºC to 35º C
 Relative humidity: 5% to 95%
Lithium-ion battery 2 x 3.7 Volt 1500 mAh

Troubleshooting
This chapter summarizes the most common problems you could encounter
with the device. If you are unable to solve the problem with the information
below, visit www.philips.com/support for a list of frequently asked questions
or contact the Consumer Care Center in your country.
Problem Possible cause Solution
The device suddenly
switches off.
The rechargeable batteries
are empty.
Charge the device. See Chapter
Charging.
The device/adapter
becomes warm during
charging
This is normal. No action required.
I cannot use the device
from the mains.
Due to safety reasons it is not
possible to use the device
from the mains.
Philips Lumea can only be used without
cord.
The 'ready to flash light'
doesn't light up when I
place the attachment on
my skin, but the cooling fan
works.
The overheat protection has
been activated.
When the overheat protection has been
activated, the fan still works. Do not
switch off the device, but let it cool down
for approx.15 minutes before you
continue to use it.
The 'ready to flash light'
lights up green but the
device does not produce a
flash when I press the flash
button.
The device needs to be reset. To reset the device, switch it off and
switch it on again.
The attachment or the filter
glass is dirty.
Clean the attachment carefully.The device produces a
strange smell.
You have not removed the
hairs on the area to be
treated properly. These hairs
may get burned and can
cause the smell.
Pretreat your skin before you use Lumea.
18
English