Instructions for use
4 Briey press the play/stop button E on the baby unit again to stop playing of the lullaby.
(Fig. 24)
Note: If you press the lullaby button K too long, no lullaby will be selected.
If the batteries of the parent unit are sufciently charged, you can take the unit with you inside and
outside the house if you attach the unit to your belt or waistband with the belt clip or if you hang it
round your neck with the neck strap. This allows you to monitor your baby while you are moving
around.
1 Insert the small pin on the back of the belt clip into the opening on the back of the parent
unit (1). Turn the belt clip to the left (2) until it locks into position (‘click’). (Fig. 26)
1 Turn the belt clip to the right (in the direction of ™) and take it out of the opening (2).
(Fig. 27)
1 Insert the small pin at the end of the neck strap into the opening on the back of the parent
unit (1). Turn the neck strap to the left (2) until it locks into position (‘click’). (Fig. 28)
1 Turn the neck strap to the right (in the direction of ™) and take it out of the opening (2).
(Fig. 29)
Reset function
This function allows you to reset the parent unit and baby unit to the default settings. You can use
this function if problems occur that cannot be solved by following the suggestions in chapter
‘Frequently asked questions’. You have to reset each unit separately.
1 Press and hold the on/off button 3 for 2 seconds to switch on the unit. (Fig. 30)
2 Press and hold the volume – button as soon as the connection light on the unit starts to
burn. (Fig. 31)
The unit has now been reset to the default factory settings.
Now do the same for the other unit.
Default settings
Parent unit
Loudspeaker volume: 1
Microphone sensitivity: 3
Sound alert: on
Temperature alert: on
Baby unit
Loudspeaker volume: 3
Nightlight: off
Lullaby: 1
’Temperature low’ alert: 14°C
’Temperature high’ alert: 30°C
,
-
-
-
-
-
-
-
-
-
ENGLISH 11