Instructions for use

Storage
When you are not going to use the baby monitor for some time, remove the batteries and
store the parent unit, the baby unit, the adapter of the baby unit and the charger in the travel
bag supplied.
You can also use the travel bag to store the baby monitor while you travel.

Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an ofcial collection point for recycling. By doing this, you help to preserve the
environment. (Fig. 35)
Batteries contain substances that may pollute the environment. Do not throw empty
batteries away with the normal household waste, but hand them in at an ofcial collection
point. Always remove the batteries before discarding the appliance or handing it in at an
ofcial collection point.

If you need information or if you have a problem, please visit the Philips website at www.philips.com
or contact the Philips Customer Care Centre in your country (you nd its phone number in the
worldwide guarantee leaet). If there is no Customer Care Centre in your country, turn to your
local Philips dealer or contact the Service Department of Philips Domestic appliances and Personal
Care BV.

This chapter lists the questions most frequently asked about the appliance. If you cannot nd the
answer to your question, contact the Customer Care Centre in your country.
Question Answer
Why do the LINK lights
not blink and do the
displays not light up when
I press the on/off button
of the baby unit and the
parent unit?
Place the parent unit in the charger and put the adapter of the
charger in a wall socket. Then press the on/off button to check if the
parent unit works. Also check if the baby unit works by pressing the
on/off button. If it does not work, replace the batteries. Then try to
establish connection between the parent unit and baby unit. If the
LINK lights are still not on, move the parent unit closer to the baby
unit, but not closer than 1 metre/3 feet. If it is still not possible to
establish a connection, use the reset function to reset the units to
their default settings.
Why does the LINK light
on the parent unit blink
and why does the unit
beep at the same time?
The parent unit and the baby unit may be out of range of each other.
Move the parent unit closer to the baby unit.
Why does the LINK light
on the baby unit blink red
and why is the message
( O) shown
on the display?
The baby unit and the parent unit are out of range of each other.
Move the parent unit closer to the baby unit.
Why does the LINK light
on the baby unit blink
red?
If the message ( O) is not shown on the display, the
batteries of the baby unit are running low. Replace the batteries.
,
,
,
,
ENGLISH14