Register your product and get support at www.philips.
1 Important safety instructions Compliance information English Contents 4 6 2 Introduction 7 3 Overview 8 8 9 Parent unit Baby unit 4 Get started Connect the baby unit to power Charge the parent unit 5 Use your baby monitor Operating range Change the microphone sensitivity ECO mode Reset the baby monitor Optimize the battery life of the parent unit 10 10 10 11 12 12 12 12 13 6 Warranty 13 7 Frequently asked questions 13 EN 3
1 Important safety instructions Know these j Use this apparatus only for its intended use as described in this manual. CAUTION k Do not overload wall outlets and extension cords as this can result in the CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This “bolt of lightning” indicates uninsulated material within your unit may cause an electrical shock.
Adult supervision This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult supervision and should not be used as such. Never place the baby unit inside the baby bed or playpen. When your baby monitor uses a power outlet, make sure that you can easily access the power outlet. For their safety, do not allow children to play with the baby monitor.
Please visit www.recycle.philips.com for additional information on a recycling center in your area. Replacement If you replace the adapters, use the type of If you replace the batteries, use the type Replace all the batteries in the unit at the same time. Assistance For assistance, visit our website www.philips.com/AVENT or call 1-800-54-AVENT (1-800-542-8368).
English 2 Introduction Congratulations on your purchase and welcome $ %&'* ; support that Philips offers, register your product at www.philips.com/AVENT. Philips AVENT is dedicated to producing caring and reliable products that give parents the reassurance that they need. This Philips AVENT baby monitor provides round-the-clock support by ensuring you can always hear your baby clearly without any distracting noise.
a 3 Overview Press and hold to turn the parent unit on or off b Parent unit / Press to change the volume c Flashes red: The battery pack is low in power. Flashes green: The battery pack is in charging mode. talk a b j c d sensitivity i e h f g k d Press and hold to activate ECO mode In blue: ECO mode is enabled.
a Baby unit English Press and hold to turn the baby unit on or off b on In green: The baby unit is turned on. e f g d h c PAGE Press to locate the parent unit Press to stop paging alerts d Microphone c b a i e Nightlight f Press to play the next lullaby j g Press to play or stop a lullaby k h / Press to change the volume i In green: The baby unit is running on batteries. Flashes red: The batteries are low in power.
4 Get started Charge the parent unit Note Connect the baby unit to power You can connect the baby unit to a power supply or insert non-rechargeable batteries to operate it. Insert non-rechargeable batteries to guarantee an automatic backup in case of power supply failure. 1 Before you connect the baby unit to a power supply, remove the lid of the battery compartment. 2 Insert four non-rechargeable 1.5V R6 AA batteries with the correct polarity (+/-) as indicated. 3 4 Reattach the lid.
English » If no link is established, the link @ beeps from time to time. 5 Use your baby monitor Tip Link the parent unit to the baby unit: 1 Press and hold on the baby unit for two seconds. » The baby unit turns on, and all indicators on the baby unit light up @ It takes about 15 seconds to establish the link between the parent unit and the baby unit.
Operating range ECO mode When you monitor your baby from a small distance, you can enable ECO mode. In ECO mode, the baby monitor consumes less energy, but still ensures that you can hear your baby clearly without any distracting noise. For the operating range in ECO mode, see Section "Operating range".
Recharge the parent unit when you see the low battery icon or hear the low battery alert tone. Fully recharge the parent unit before you use it again, as completely draining the rechargeable batteries may reduce their life. Remove the rechargeable batteries from the parent unit if you are not going to use it for a week or longer. Always fully recharge the parent unit after a long period of disuse. Remove the parent unit from the charging dock after it is fully charged.
7 Frequently asked questions Why doesn't the link indicator on the parent unit light up when I press on the parent unit? Connect the parent unit to a power supply. Reset the parent unit to the default settings. Why doesn't the on indicator on the baby unit light up when I press on the baby unit? Replace the batteries in the baby unit or connect the baby unit to a power supply. Reset the baby unit to the default settings.
English Why is the operating time of my parent unit shorter than 24 hours? When the parent unit is charged for the = than 24 hours. The rechargeable battery pack only reaches its full capacity after you charge and discharge it at least 4 times. Decrease the volume and the microphone sensitivity. Why does the charging time of the parent unit exceed 8 hours? J < non-use, the charging time is 10 hours.
In US manufactured for Philips Consumer Lifestyle, A division of Philips Electronics North America Corporation, P.O. Box 10313, Stamford, CT 06904 In Canada imported for Philips Electronics Ltd, 281 Hillmount Road, Markham, ON L6C 2S3 Call TOLL-FREE 1.800.54.AVENT En EE.UU. faricado para Philips Consumer Lifestyle, Una división de Philips Electronics North America Corporation, P.O.
