User manual

10
EN
4 Get started
Connect the baby unit to
power
You can connect the baby unit to a power
supply or insert non-rechargeable batteries to
operate it. Insert non-rechargeable batteries
to guarantee an automatic backup in case of
power supply failure.
1 Before you connect the baby unit to a
power supply, remove the lid of the battery
compartment.
2 Insert four non-rechargeable 1.5V R6 AA
batteries with the correct polarity (+/-) as
indicated.
3 Reattach the lid.
4 Connect a supplied adapter to the baby
unit and to a power supply.
Charge the parent unit
Note
 Make sure that the parent unit is disconnected from the
power supply and turned off.
1 Remove the lid of the battery
compartment.
2 Insert the supplied rechargeable battery
pack with the correct polarity (+/-) as
indicated.
3 Reattach the lid.
4 Connect a supplied adapter to the parent
unit and to a power supply to start
charging.
Tip
 The battery pack only reaches the full capacity after
you charge it for four times.
 
the operating time is less than 24 hours.
 The normal charging time is 8 hours, and the normal
operating time is 24 hours.
 
minutes before the battery pack runs out of power.