User's Manual

3 Select ‘Range’ with the + and - buttons.
4 Press the OK button to confi rm.
5 Set the desired minimum temperature with the + and - buttons.
6 Press the OK button to confi rm.
7 Set the desired maximum temperature with the + and - buttons.
8 Press the OK button to confi rm.
The message ‘Saved’ appears on the display.
Note: If the temperature in the baby’s room drops below or exceeds the set
temperature range, the display of the parent unit is on continuously. This causes
the unit to consume more power.
Temperature alert on/off
Note: If the temperature alert is activated too often, reduce the set minimum
temperature and/or increase the set maximum temperature (see ‘Setting room
temperature range’).
If the temperature alert is switched on, the parent unit beeps if the actual
room temperature exceeds the set maximum temperature or drops below
the set minimum temperature. In addition, the backlight of the parent unit
display goes on and ‘High’ or ‘Low’ appears on the display. If no minimum
and maximum temperatures have been set, the temperature alert is given
when the room temperature drops below 57°F or rises above 86°F.
1 Select ‘Temperature’ with the + and - buttons.
2 Press the OK button to confi rm.
3 Select ‘Alert’ with the + and - buttons.
4 Press the OK button to confi rm.
5 If the alert is off, the display shows ‘On?’. Press the OK button to
switch on the alert. If the alert is on, the display shows ‘Off?’. Press
the OK button to switch off the alert.
Reset function
This function in the menu of the parent unit allows you to reset both the
parent unit and the baby unit to the default settings at the same time. You
can use this function if problems occur that you cannot solve by following
the suggestions in chapter ‘Frequently asked questions’.
1 Select ‘Reset’ with the + and - buttons.
2 Press the OK button to confi rm.
The message ‘Confi rm?’ appears on the display of the parent unit.
3 Press the OK button to confi rm.
The parent unit switches off and then switches on again.
The units have now both been reset to the default factory settings.
Default settings
Parent unit
Loudspeaker volume: 1
Microphone sensitivity: 3
Sound alert: off
,
,
,
,
-
-
-
ENGLISH20
4222.002.7190.1.indd 204222.002.7190.1.indd 20 03-09-2008 14:31:0203-09-2008 14:31:02