User manual

Assembly
When you assemble the trainer cup,
make sure you place the cap vertically
onto the cup so that the nipple sits
upright (see image for more details).
To remove the cap, place your hand
over the cap and your thumb in the
dimple of the cap. The nipple is easier
to assemble if you wriggle it upwards
instead of pulling it up in a straight
line. Make sure you pull the nipple
through until its lower part is even
with the screw ring.
Cleaning
- Clean all parts before each use.
- After every use, take all items
apart, wash in warm soapy water
and rinse thoroughly. Then
sterilize using a Philips Avent
sterilizer or boil for 5 minutes.
Make sure that you wash your
hands thoroughly and that the
surfaces are clean before contact
with sterilized components.
- Make sure all parts are taken
apart when sterilizing.
- Excessive concentration of
detergents may eventually cause
plastic components to crack. Should
this occur, replace immediately.
- Dishwasher safe - food colorings
may discolor components.
Choosing the right nipple for
your baby
The Philips Avent nipples are
available with dierent ow rates to
help your baby with drinking. Over
time you can change the nipple
accommodating the individual
needs of your baby. Philips Avent
nipples are clearly numbered on
the side to indicate ow rate (see
image). Make sure you use a nipple
with the correct ow rate when you
feed your baby. Use a lower ow
rate if your baby chokes, is leaking