User manual

16
Pumping instructions
Warning: Before you remove the pump body from your breast, always switch o the
breast pump to release the vacuum.
Warning: Do not continue pumping for more than 5 minutes at a time if you do not
succeed in expressing any milk. Try to express at another time during the day.
Warning: If the process becomes very uncomfortable or painful, stop using the pump
and consult your healthcare professional.
Note: If you regularly express more than 125 ml/4  oz per session, you can purchase and use a
260 ml/9  oz Philips Avent Natural bottle to prevent overlling and spillage.
1. Wash your hands
thoroughly with soap
and water and make
sure that your breast is
clean.
2. Place the breast
pump kit onto your
breast. Make sure that
you center your nipple.
3. Press and hold the
on/o button until the
device switches on. The
indicator lights go on to
indicate that the device
is in stimulation mode.
4. The breast pump
starts in stimulation
mode and slowly
increases its vacuum
to the last used
stimulation suction
level (or level 5 when
used for the rst time).
5. Use the 'level up'
and 'level down'
buttons to change the
suction level to your
preference.
6. After 90 seconds
the breast pump will
switch smoothly to
expression mode and
slowly increase its
vacuum to the last used
expression suction level
(or level 11 when used
for the rst time).
7. If your milk starts
owing earlier or if
you want to switch
from expression to
stimulation mode, you
can switch modes with
the mode selection
button.
8. Briey press the on/
o button if you want
to pause. To continue,
briey press the on/o
button again.
3 sec.
90 sec.
English