Philips Selecon - Dallas 10911 Petal Street Dallas, TX 75238 Tel: 214-647-7880 Fax: 214-647-8031 Philips Selecon - Auckland 19-21 Kawana Street Northcote, Auckland 0627 New Zealand Tel: +64 9 481 0100 Fax: +64 9 481 0101 Philips Selecon - New York 267 5th Ave, 4th Floor New York, NY 10016 Tel: 212-213-8219 Fax: 212-532-2593 Philips Selecon - Europe Marssteden 152 Enschede 7547 TD The Netherlands Tel: +31 53 4500424 Fax: +31 53 4500425 Philips Selecon - Asia Limited Room 6-10, 20/F Delta House 3 On Yiu S
PL1IRR Remote Control User’s Guide IMPORTANT INFORMATION Warnings and Notices When using electrical equipment, basic safety precautions should always be followed including the following: a. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. b. Do not use outdoors. c. Do not use near gas or electric heaters. d. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. e. Do not use this equipment for other than intended use. f. Refer service to qualified personnel.
PL1IRR Remote Control User’s Guide TABLE OF CONTENTS IMPORTANT INFORMATION Warnings and Notices...................................................................................................................................... 1 Philips Selecon Limited Three-Year Warranty ............................................................................................... 1 TABLE OF CONTENTS PREFACE About this Guide..............................................................................................
PL1IRR Remote Control User’s Guide PREFACE About this Guide The document provides installation and operation instructions for the following product: • PL1IRR Remote Control (includes two AAA batteries and user’s guide) Please read all instructions before using this product. Retain this manual for future reference. Additional information for PL1 LED Luminaires including product descriptions may be downloaded at www.seleconlight.
PL1IRR Remote Control User’s Guide PL1IRR PROGRAMMING REMOTE OVERVIEW Infrared Remote Control Features Laser / IR Window Laser and IR programming emits from this end. Program Enter - After the luminaire to be programmed is selected (by Laser), press Enter to set the luminaire to programming mode. Laser (Luminaire Selector) - Press Laser to select individual luminaire for programming / adjustment. PL1IRR LED (indicator) - PROGRAM EXIT LASER ENTER CANCEL Exit - Press to exit programming mode.
PL1IRR Remote Control User’s Guide OPERATION AND PROGRAMMING Using the PL1IRR Infrared Remote Control To select and program PL1 LED luminaire with PL1IRR remote: Note: The IR, on the PL1 LED luminaire, must be set to "Enabled" in order for the PL1IRR remote to communicate and control the fixture. Refer to PL1 LED Luminaire Installation & User’s Manual on luminaire menu settings. Step 1.