SHB2505
blue blue Please note that the right earpiece is the “Master device” and the left Earpiece is the “Slave” device. Before the first time use, put them into charging case to fully charge for 3 hours. 3 Take both earpieces from the charging case, the earpiece will power on automatically. There will be a voice “Power on” and a voice “Pairing”. Then, there will be a voice“ R channel” on right earpiece and “L Channel” on left earpiece after paring each other.
The LED on Right earpiece flashes in white and blue for 3 mins. The LED on Right earpiece flashes in white and blue for 3 mins. Single earbud pairing ( Mono mode) Take the right earpiece ("Master device" ) from the charging case, the earpiece will power on automatically. There will be a voice ”Power on” and a voice “ Pairing". Then, there will be a voice” R channel” on right earpiece. Turn on the Bluetooth function on your device, search for" Philips SHB2505” tap to connect. ( Please refer to P.
Take both earpieces from the charging case, the earpiece will power on and reconnect automatically. Take both earpieces from the charging case, the earpiece will power on and reconnect automatically If no device is connected, the earpieces will automatically turn off after 3 mins 5 3 times.
white will flashe 2 times per 3 mins /Left /Left 2 once. /Left Battery LED indicator on headset status It will show a battery indicator on Bluetooth device after connected to headset.
Battery LED indicator on Charging case with USB cable While charging earbud, Blue LED will light on One LED will flash per second for 0-25% power Two LED will flash per second for 25-50% power Three LED will flash per second for 50-75% power Four LED will flash per second for 75-100% power Put both earpieces back to charging case. Hold and press left & right earpieces function button for 5 seconds. Take both earpieces from the charging case, the earpiece will power on automatically.
3 3 60 5.
put both earpieces back to charging case for 5 seconds and thak them out. put both earpieces back to charging case for 5 seconds and thak them out.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
