User manual

8 EN
Call control
• Pick up/hang up a call: tap once.
• Reject an incoming call: tap and hold.
• Switch caller during a call: slide forward.
• Mute/unmute the microphone in a call:
press / .
LED indicator status (right side of
headphones)
Headphones status Indicator
The headphones are
connected to a Bluetooth
device, while the
headphones in standby
mode or while you are
listening to music.
The blue LED
ashes for every
8 seconds.
The headphones are ready
for pairing.
The LED ashes
blue and white
alternately.
The headphones are on
but not connected to a
Bluetooth device.
The blue LED
ashes quickly.
Low battery. The white LED
ashes slowly.
Battery is fully charged. The white LED
is off.
Wired connection
You can also use the headphones with the
audio cable provided when the battery is too
low. Make sure the headphones turned off
before using the audio cable. Connect the
supplied audio cable to the headphones and
external audio device.
Connect to ANC (active
noise cancelation)
Enable ANC
• Press and hold the ANC on/off button for
2 seconds to enable noise cancelation.
• Press and hold the ANC on/off button for
2 seconds to disable noise cancelation.
Tip
• When the ANC function is not required, switch off the
ANC on/off button to continue your call or listening
to music.
Enable awareness mode
• Press the ANC on/off button to enable
awareness.
• Press the ANC on/off button to disable
awareness.
» The ANC function will be on/off
automatically.
Note
• The awareness mode can be enabled only when ANC
is also enabled.