CD Soundmachine Register your product and get support at www.philips.
1 8 DYNAMIC BASS BOOST 0 @ VOLUME TUNING 7 1 O OP EN C D S O U N D M AC H I N E A Z 1 0 2 2 3 LIF SH U FF L O PR E RE PE G T T 6 5 AT 4
2
3 7 4 8 5 PROG X 6 ALL
English Controls/Power Supply Congratula tions on your purchase and welcome to Philips! CAUTION – Visible and invisible laser radiation. If the cover is open, do not look at the beam. – High voltage! Do not open.You run the risk of getting an electric shock. The machine does not contain any userserviceable parts. – Modification of the product could result in hazardous radiation of EMC or other unsafe operation.
Power Supply Using AC power Warning: Always check you have completely switched off the set, before you change or disconnect power supply. 1 Check if the power voltage, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the power cord to the AC MAINS~ inlet and the wall socket. The set is now connected and ready for use.
CD Player Playing a CD • This CD player plays Audio Discs including CD-Recordables (CD-R) and CD-Rewritables (CD-RW). • MP3, CD-ROM, CD-I, CDV, VCD, DVD or computer CDs are not possible for playback. Selecting a different track • Press ∞ / § once or repeatedly until the desired track number appears in the display. • In the pause/stop position, press 2; to start playback.
CD Player Programming track numbers Different play modes: REPEAT. and SHUFFLE (See 6, 7) You may store up to 20 tracks in the desired sequence. If you like, store any track more than once. 1 2 3 In the stop position, press PROG to activate programming. REPEAT You can play the current track or the whole disc repeatedly, and combine REPEAT modes with PROG (PROGRAM). ÜÜDisplay: PROG and 00 flash. (See 5) REP – plays the current track continuously. Press ∞ or § to select your desired track number.
Maintenance & Safety (See 8) CD player and CD handling • If the CD player cannot read CDs correctly, use a cleaning CD to clean the lens before taking the set to repair. • The lens of the CD player should never be touched! • Sudden changes in the surrounding temperature can cause condensation on the lens of your CD player. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates.
Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: D o not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
Environmental information All unnecessary packaging material has been omitted. The packaging can be easily separated into three materials: cardboard, polystyrene and plastic. Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging, dead batteries and old equipment. Specifications Power consumption....................................................................................................
Meet Philips at the Internet http://www.philips.com CLASS 1 LASER PRODUCT AZ102S AZ102C AZ102N AZ102G AZ102V AZ102R AZ102B Printed in China AZ102_98_UM_V3.